A. 180o
B. 270o
C. 90o
D. 0o
Advertisement
Related Mcqs:
- If the maximum collector current due to signal alone is 3 mA, then zero signal collector current should be at least equal to___________________?
A. 6 mA
B. mA
C. 3 mA
D. 1 mA - In a single stage transistor amplifier, RC and RL represent collector resistance and load resistance respectively. The transistor sees a d.c. load of _____________________?
A. RC + RL
B. RC || RL
C. RL
D. RC - If RC and RL represent the collector resistance and load resistance respectively in a single stage transistor amplifier, then a.c. load is____________________?
A. RL + RC
B. RC || RL
C. RL – RC
D. RC - A single stage transistor amplifier with collector load RC and emitter resistance RE has a d.c. load of ________________________?
A. RC
B. RC || RE
C. RC – RE
D. RC + RE - If the collector supply is 10V, then collector cut off voltage under d.c. conditions is _______________?
A. 20 V
B. 5 V
C. 2 V
D. 10 V - If the power rating of a transistor is 1W and collector current is 100mA, then maximum allowable collector voltage is________________?
A. 1V
B. 100V
C. 20V
D. 10V - What will be the collector efficiency of a power amplifier having zero signal power dissipation of 5 watts and a.c. power output of 2 watts ?
A. 20%
B. 80%
C. 40%
D. 50% - An amplifier receives 0.1 W of input signal and delivers 15 W of signal power. What is the power gain in db?
A. 8 db
B. 6 db
C. 5 db
D. 4 db - The value of collector load RC in a transistor amplifier is _______________the output impedance of the transistor?
A. The same as
B. Less than
C. More than
D. None of the above - Two 3.3 kΩ resistors are in series and this series combination is in parallel with a 4.7 kΩ resistor. The voltage across one of the 3.3 kΩ resistors is 12 V. The voltage across the 4.7 kΩ resistor is_________?
A. 24 V
B. 12 V
C. 0 V
D. 6 V
Advertisement
