A. there is enthalpy drop both in fixed and moving blades
B. there is enthalpy drop only in fixed blades
C. there is enthalpy drop only in moving blades
D. none of the above
Related Mcqs:
- In De Laval steam turbine___________?
A. the pressure in the turbine rotor is approximately same as in con¬denser
B. the pressure in the turbine rotor is higher than pressure in the con¬denser
C. the pressure in the turbine rotor gradually decreases from inlet to exit from condenser
D. none from the above - For Parson’s reaction steam turbine, degree of reaction is____________?
A. 75%
B. 100%
C. 50%
D. 60% - The isentropic expansion of steam through nozzle for the steam initially superheated at inlet is approximated by equation__________?
A. pvls=C
B. pv1126 = C
C. pv1A = C
D. pv = C - The ratio of exit pressure to inlet pressure for maximum mass flow rate per unit area of steam through a nozzle when steam is initially dry saturated is___________?
A. 0.6
B. 0.578
C. 0.555
D. 0.5457 - The ratio of exit pressure to inlet pressure of maximum mass flow rate per area of steam through a nozzle when steam is initially superheated is__________?
A. 0.555
B. 0.578
C. 0.5457
D. 0.6 - The isentropic expansion of steam through nozzle for the steam initially dry saturated at inlet is approximated by equation?
A. pv = C
B. pv1A = C
C. pv1i = C
D. pv - Steam turbines commonly used in steam power station are__________?
A. condensing type
B. non-condensing type
C. none of the above - Steam pressure in a steam power station, which is usually kept now-a-days is of the order of____________?
A. 20 kgf/cm2
B. 50 kgf/cm2
C. 100 kgf/cm2
D. 150 kgf/cm2 - The effect of considering friction losses in steam nozzle for the same pressure ratio leads to________?
A. increase in exit velocity from the nozzle
B. decrease in exit velocity from the nozzle
C. no change in exit velocity from the nozzle
D. increase or decrease depending upon the exit quality of steam - Steam turbines are governed by the following methods_____________?
A. Throttle governing
B. Nozzle control governing
C. By-pass governing
D. all of the above