A. mechanical
B. chemical
C. heat
D. sound
Related Mcqs:
- In _________ system fuel from a central pulverizing unit is delivered to a bunker and then to the various burners?
A. unit
B. central
C. none of the above - Which of the following power plant has least fuel transportation______________?
A. nuclear power plants
B. diesel generating plants
C. thermal power plants
D. steam power stations - The fuel used in nuclear reactor is_____________?
A. radium
B. cadmium
C. uranium
D. all of the above - The commercial sources of energy are____________?
A. solar, wind and biomass
B. fossil fuels, hydropower and nuclear energy
C. wood, animal wastes and agriculture wastes
D. none of the above - The energy radiated by sun on a bright sunny day is approximately______________?
A. 700 W/m2
B. 800 W/m2
C. 1 kW/m2
D. 2 kW/m2 - The overall efficiency of thermal power plant is equal to____________?
A. Rankine cycle efficiency
B. Carnot cycle efficiency
C. Regenerative cycle efficiency
D. Boiler efficiency x turbine efficiency x generator efficiency - Binary’vapour cycles are used to_____________?
A. increase the performance of the condenser
B. increase the efficiency of the plant
C. increase efficiency of the turbine - The ratio of exit pressure to inlet pressure for maximum mass flow rate per unit area of steam through a nozzle when steam is initially dry saturated is___________?
A. 0.6
B. 0.578
C. 0.555
D. 0.5457 - The efficiency of a modern boiler using coal and heat recovery equipment is about_____________?
A. 25 to 30%
B. 40 to 50%
C. 65 to 70%
D. 85 to 90% - If the load factor of a power station is high then its cost of generation will be_______?
A. High.
B. Low.
C. Remain same.
D. Depend upon plant type.