A. unit
B. central
C. none of the above
Related Mcqs:
- In fuel cell, the ___________ energy is converted into electrical energy?
A. mechanical
B. chemical
C. heat
D. sound - Which of the following power plant has least fuel transportation______________?
A. nuclear power plants
B. diesel generating plants
C. thermal power plants
D. steam power stations - The fuel used in nuclear reactor is_____________?
A. radium
B. cadmium
C. uranium
D. all of the above - The ratio of exit pressure to inlet pressure for maximum mass flow rate per unit area of steam through a nozzle when steam is initially dry saturated is___________?
A. 0.6
B. 0.578
C. 0.555
D. 0.5457 - Under-feed stokers work best for _________ coals high in volatile matter and with caking tendency?
A. anthracite
B. lignite
C. semibituminous and bituminous - Rankine cycle operating on low pressure limit of p1 an 1 high pressure limit of p2__________?
A. has higher the renal efficiency than the carnot cycle operating between same pressure limits
B. has lower the”nal efficiency than carnot cycle operating between same pressure limit?
C. has same thermal efficiency as carnot cycle operating between same pressure limits
D. may be more or less depending upon the magnitude of p1 and p2 - The draught produced by chimney of given height at given outside temperature___________?
A. decreases if the chimney gas temperature increases
B. increases if the chimney gas temperature increases
C. remains same irrespective of chimney gas temperature
D. may increase or decrease - The critical pressure ratio of a convergent nozzle is defined as_____________?
A. the ratio of outlet pressure to inlet pressure of nozzle
B. the ratio of inlet pressure to outlet pressure of nozzle
C. the ratio of outlet pressure to inlet pressure only when mass flow rate per unit area is minimum
D. the ratio of outlet pressure to inlet pressure only when mass flow rate = c - In jet type condensers___________?
A. cooling water passes through tubes and steam surrounds them
B. steam passes through tubes and cooling water surrounds them
C. steam and cooling water mix
D. steam and cooling water do not mix - Compounding of steam turbine is done for_______________?
A. reducing the work done
B. increasing the rotor speed
C. reducing the rotor speed
D. balancing the turbine