A. Sine wave
B. Square wave
C. Saw – tooth wave
D. Trapezoidal wave
Related Mcqs:
- Due to non sinusoidal waveform of the input current, the power factor of the rectifier is____________?
A. Negatively affected by firing angle
B. Negatively affected by distortion of the input current
C. Positively affected by both firing angle and distortion of the input current
D. Both (a) and (b) - The ac output voltage waveform of VSI and AC output current waveform of CSI respectively is composed of___________?
A. High dv / dt, low di / dt
B. Low dv / dt, low di / dt
C. Low dv / dt, high di / dt
D. High dv / dt, high di / dt - In a silicon controlled rectifier, the load is connected___________?
A. Across anode
B. In series with anode
C. Across cathode
D. In series with cathode - A single phase full bridge inverter can operated in load commutation mode in case load consist of______?
A. RL.
B. RLC underdamped.
C. RLC overdamped.
D. RLC critically damped - A single phase full bridge inverter can operate in load commutation mode in case load consists of____________?
A. RL.
B. RLC underdamped.
C. RLC overdamped.
D. RLC critically damped. - A single phase one pulse controlled circuit has a resistance R and counter emf E load 400 sin(314 t) as the source voltage. For a load counter emf of 200 V, the range of firing angle control is _____?
A. 30° to 150°.
B. 30° to 180°.
C. 60° to 120°.
D. 60° to 180°. - In a 3 phase bridge rectifier the ripple frequency is _____________?
A. Equal to the input frequency
B. Twice the input frequency
C. Three times the input frequency
D. Six times the input frequency - Silicon controlled rectifier can be turned on____________?
A. By applying a gate pulse and turned off only when current becomes zero
B. And turned off by applying gate pulse
C. By applying a gate pulse and turned off by removing the gate pulse
D. By making current non zero and turned off by making current zero - A full wave rectifier with resistive load produces___________?
A. Second harmonic
B. Third harmonic
C. Fifth harmonic
D. Do not produce harmonics - The advantage of using free – wheeling diode in half controlled bridge converter is that
A. There is always a path for the dc current independent of the ac line
B. There is always a path for the ac current independent of the ac line
C. There is always a path for the dc current dependent of the ac line
D. There is always a path for the ac current independent of the ac line
