A. Second harmonic
B. Third harmonic
C. Fifth harmonic
D. Do not produce harmonics
Related Mcqs:
- In a single phase full wave rectifier, during blocking state the pea inverse voltage of diode is______________?
A. V m
B. 2 V m
C. V m / 2
D. 4 V m - In a full wave rectifier, the rectification ratio is approximately equal to____________?
A. 61%
B. 71%
C. 81%
D. 91% - In a 3 phase half wave rectifier, when firing angle is less than 90 degree, then the average dc output voltage becomes__________________?
A. Positive
B. Negative
C. Zero
D. None of these - A single phase full bridge inverter can operated in load commutation mode in case load consist of______?
A. RL.
B. RLC underdamped.
C. RLC overdamped.
D. RLC critically damped - A single phase full bridge inverter can operate in load commutation mode in case load consists of____________?
A. RL.
B. RLC underdamped.
C. RLC overdamped.
D. RLC critically damped. - In a silicon controlled rectifier, the load is connected___________?
A. Across anode
B. In series with anode
C. Across cathode
D. In series with cathode - The input current waveform of a bridge controlled rectifier when the load is perfectly filtered is___________?
A. Sine wave
B. Square wave
C. Saw – tooth wave
D. Trapezoidal wave - A single phase one pulse controlled circuit has a resistance R and counter emf E load 400 sin(314 t) as the source voltage. For a load counter emf of 200 V, the range of firing angle control is _____?
A. 30° to 150°.
B. 30° to 180°.
C. 60° to 120°.
D. 60° to 180°. - Due to non sinusoidal waveform of the input current, the power factor of the rectifier is____________?
A. Negatively affected by firing angle
B. Negatively affected by distortion of the input current
C. Positively affected by both firing angle and distortion of the input current
D. Both (a) and (b) - Transformer utilization factor is a measure of the merit of a rectifier circuit. It is the ratio of_______________?
A. AC input power to the transformer volt – amp rating required by secondary
B. AC input power to the transformer volt – amp rating required by primary
C. DC output power to the transformer volt – amp rating required by secondary
D. DC output power to the transformer volt – amp rating required by primary
