A. VCE consideration
B. VBE consideration
C. IB consideration
D. None of the above
Related Mcqs:
- In a particular biasing circuit, the value of RE is about _________________?
A. 10 kO
B. 1 MO
C. 100 kO
D. 800 O - If the maximum collector current due to signal alone is 3 mA, then zero signal collector current should be at least equal to___________________?
A. 6 mA
B. mA
C. 3 mA
D. 1 mA - If the power rating of a transistor is 1W and collector current is 100mA, then maximum allowable collector voltage is________________?
A. 1V
B. 100V
C. 20V
D. 10V - If the collector supply is 10V, then collector cut off voltage under d.c. conditions is _______________?
A. 20 V
B. 5 V
C. 2 V
D. 10 V - In a single stage transistor amplifier, RC and RL represent collector resistance and load resistance respectively. The transistor sees a d.c. load of _____________________?
A. RC + RL
B. RC || RL
C. RL
D. RC - If RC and RL represent the collector resistance and load resistance respectively in a single stage transistor amplifier, then a.c. load is____________________?
A. RL + RC
B. RC || RL
C. RL – RC
D. RC - A single stage transistor amplifier with collector load RC and emitter resistance RE has a d.c. load of ________________________?
A. RC
B. RC || RE
C. RC – RE
D. RC + RE - If biasing is not done in an amplifier circuit, it results in________________?
A. Decrease in the base current
B. Unfaithful amplification
C. Excessive collector bias
D. None of the above - Transistor biasing is done to keep _____________in the circuit?
A. Proper direct current
B. Proper alternating current
C. The base current small
D. Collector current small - The biasing circuit has a stability factor of 50. If due to temperature change, ICBO changes by 1 µA, then IC will change by___________________?
A. 100 µA
B. 25 µA
C. 20 µA
D. 50 µA