A. 3 V
B. 8 V
C. 6 V
D. 7 V
Related Mcqs:
- If the power rating of a transistor is 1W and collector current is 100mA, then maximum allowable collector voltage is________________?
A. 1V
B. 100V
C. 20V
D. 10V - If the collector supply is 10V, then collector cut off voltage under d.c. conditions is _______________?
A. 20 V
B. 5 V
C. 2 V
D. 10 V - If the maximum collector current due to signal alone is 3 mA, then zero signal collector current should be at least equal to___________________?
A. 6 mA
B. mA
C. 3 mA
D. 1 mA - In a CE amplifier, the phase difference between voltage across collector load RC and signal voltage is _________________?
A. 180o
B. 270o
C. 90o
D. 0o - A series resonant band-stop filter consists of a 68 Ω resistor, a 110 mH coil, and a 0.02 µF capacitor. The internal resistance, RW, of the coil is 4 Ω. Input voltage is 200 mV. Output voltage is taken across the coil and capacitor in series. What is the output voltage magnitude at f0?
A. 1.1 mV
B. 11.1 mV
C. 111 mV
D. 200 mV - A series resonant band-pass filter consists of a 2 mH coil, a 0.005 µF capacitor, and a 120 Ω resistor. The winding resistance of the coil is 12 Ω. The output voltage is taken off the resistor. Input voltage is 12 Vrms. What is the output voltage magnitude at the center frequency (f0)?
A. 10.9 V
B. 1.09 V
C. 1.1 V
D. 12 V - In voltage divider bias, VCC = 25 V; R1 = 10 kO; R2 = 2.2 V ; RC = 3.6 V and RE =1 kO. What is the emitter voltage?
A. 7 V
B. 3 V
C. V
D. 8 V - The stability factor of a collector feedback bias circuit is_______________ that of base resistor bias?
A. The same as
B. More than
C. Less than
D. None of the above - A silicon transistor is biased with base resistor method. If ß=100, VBE =0.7 V, zero signal collector current IC = 1 mA and VCC = 6V , what is the value of the base resistor RB ?
A. 105 kO
B. 530 kO
C. 315 kO
D. None of the above - In a base resistor method, if the value of ß changes by 50, then collector current will change by a factor ___________________?
A. 25
B. 50
C. 100
D. 200