For proper operation of the transistor, its collector should have___________________?

Related Mcqs:

1. If the power rating of a transistor is 1W and collector current is 100mA, then maximum allowable collector voltage is________________?

   A. 1V B. 100V C. 20V D. 10V...

2. In a single stage transistor amplifier, RC and RL represent collector resistance and load resistance respectively. The transistor sees a d.c. load of _____________________?

   A. RC + RL B. RC || RL C. RL D. RC...

3. The value of collector load RC in a transistor amplifier is _______________the output impedance of the transistor?

   A. The same as B. Less than C. More than D. None of the above...

4. If the maximum collector current due to signal alone is 3 mA, then zero signal collector current should be at least equal to___________________?

   A. 6 mA B. mA C. 3 mA D. 1 mA...

5. If the collector supply is 10V, then collector cut off voltage under d.c. conditions is _______________?

   A. 20 V B. 5 V C. 2 V D. 10 V...

6. A silicon transistor is biased with base resistor method. If ß=100, VBE =0.7 V, zero signal collector current IC = 1 mA and VCC = 6V , what is the value of the base resistor RB ?

   A. 105 kO B. 530 kO C. 315 kO D. None of the above...

7. If RC and RL represent the collector resistance and load resistance respectively in a single stage transistor amplifier, then a.c. load is____________________?

   A. RL + RC B. RC || RL C. RL – RC D. RC...

8. A single stage transistor amplifier with collector load RC and emitter resistance RE has a d.c. load of ________________________?

   A. RC B. RC || RE C. RC – RE D. RC + RE...

9. For proper amplification by a transistor circuit, the operating point should be located at the_____________ of the d.c. load line?

   A. The end point B. Middle C. The maximum current point D. None of the above...

10. The maximum collector efficiency of class B operation is ________________?

    A. 50% B. 90% C. 5% D. 5%...