Hot rolled sheets have ___________ value of permeability?

Related Mcqs:

1. The cold rolled grain oriented steel has ___________ permeability in the direction of the grain orientation?

   A. minimum B. maximum C. nil D. none of the above...

2. The cold rolled grain oriented steel has _________ permeability in the direction of the grain orientation?

   A. minimum B. maximum C. nil D. none of the above...

3. In transformers using hot rolled steel, the cross-section of the yoke is made about __________ greater than that of the core?

   A. 5 percent B. 10 percent C. 15 percent D. 30 percent E. none of the above...

4. The usual values of maximum flux densities for distribution transformers using hot rolled silicon steel are______________?

   A. 0.5 to 0.8 Wb/m2 B. 0.8 to 1.0 Wb/m2 C. 1.1 to 1.35 Wb/m2 D. 1.4 to 1.8 Wb/m2...

5. For 275 kV transformers, using cold rolled grain oriented steel, which of the following values of flux density may be used?

   A. 1.0 Wb/m2 B. 1.1 Wb/m2 C. 1.3 Wb/m2 D. 1.6 Wb/m2 E. None of the above...

6. __________ has a low relative permeability and is used principally in field frames when cost is of primary importance and extra weight is not objectionable?

   A. Cast steel B. Aluminium C. Soft steel D. Cast iron...

7. Materials exhibiting zero value of resistivity are known as ____________ ?

   A. conductors B. semiconductors C. insulators D. superconductors...

8. The value of exciting or magnetizing current depends upon which of the following factors ?

   A. Total m.m.f. required B. The number of turns in the exciting winding C. The way in which the winding is distributed D. All of the above...

9. In a D.C. machine, the value of peripheral speed should not, normally, exceed___________?

   A. 10 m/s B. 20 m/s C. 30 m/s D. 40 m/s...

10. D.C. machines designed with a large value of air gap length have_____________?

    A. worst, ventilation B. poor ventilation C. better ventilation D. none of the above...