Torque developed by a D.C. motor depends upon_____________?

Related Mcqs:

1. In a D.C. series motor, if the armature current is reduced by 50%, the torque of the motor will be equal to

   A. 100% of the previous value B. 50% of the previous value C. 25% of the previous value D. 10% of the previous value E. none of the above...

2. The ratio of starting torque to full-load torque is least in case of____________?

   A. series motors B. shunt motors C. compound motors D. none of the above...

3. Which of the following load normally needs starting torque more than the rated torque?

   A. Blowers B. Conveyors C. Air compressors D. Centrifugal pumps...

4. By looking at which part of the motor, it can be easily confirmed that a particular motor is D.C. motor?

   A. Frame B. Shaft C. Commutator D. Stator...

5. Flywheel is used with D.C. compound motor to reduce the peak demand by the motor, compound motor will have to be_____________?

   A. level compounded B. under compounded C. cumulatively compounded D. differentially compounded...

6. One D.C. motor drives another D.C. motor. The second D.C. motor when excited and driven_______________?

   A. runs as a generator B. does not run as a generator C. also runs as a motor comes to stop after sometime...

7. Following motor is used where high starting torque and wide speed range control is required?

   A. Single phase capacitor start B. Induction motor C. Synchronous motor D. D.C. motor E. None of the above...

8. The armature torque of the D.C. shunt motor is proportional to____________?

   A. field flux only B. armature current only C. both A. and B. D. none of the above...

9. The mechanical power developed by a shunt motor will be maximum when the ratio of back e.m.f. to applied voltage is______________?

   A. 4.0 B. 2.0 C. 1.0 D. 0.5...

10. For which of the following applications a D.C. motor is preferred over an A.C. motor ?

    A. Low speed operation B. High speed operation C. Variable speed operation D. Fixed speed operation...