A. it limits the speed of the motor
B. it limits the starting current to a safe value
C. it starts the motor
D. none of the above
Related Mcqs:
- A direct on line starter is used: for starting motors___________?
A. up to 5 H.P
B. up to 10 H.P
C. up to 15 H.P
D. up to 20 H.P - In a manual shunt motor starter?
A. over load relay is connected in series and no volt relay in parallel with the load
B. over load relay is connected in parallel and no volt relay in series with the load
C. over load relay and no volt relay are both connected in series with the load
D. over load relay and no volt relay are both connected in parallel with the load - Following motor is used where high starting torque and wide speed range control is required?
A. Single phase capacitor start
B. Induction motor
C. Synchronous motor
D. D.C. motor
E. None of the above - By looking at which part of the motor, it can be easily confirmed that a particular motor is D.C. motor?
A. Frame
B. Shaft
C. Commutator
D. Stator - Flywheel is used with D.C. compound motor to reduce the peak demand by the motor, compound motor will have to be_____________?
A. level compounded
B. under compounded
C. cumulatively compounded
D. differentially compounded - One D.C. motor drives another D.C. motor. The second D.C. motor when excited and driven_______________?
A. runs as a generator
B. does not run as a generator
C. also runs as a motor comes to stop after sometime - A three point starter is considered suitable for______________?
A. shunt motors
B. shunt as well as compound motors
C. shunt, compound and series motors
D. all D.C. motors - Three point starter can be used for______________?
A. series motor only
B. shunt motor only
C. compound motor only
D. both shunt and compound motor - The starting resistance of a D.C. motor is generally_______________?
A. low
B. around 500 Q
C. 1000 Q
D. infinitely large - As there is no back e.m.f. at the instant of starting a D.C. motor, in order to prevent a heavy current from flowing though the armature circuit____________________?
A. a resistance is connected in series with armature
B. a resistance is connected parallel to the armature
C. armature is temporarily open circuited
D. a high value resistor is connected across the field winding
