A. 12 mm
B. 6 mm
C. 20 mm
D. 22 mm
Related Mcqs:
- The thickness of the topping of a ribbed slab, varies between________________?
A. 3 cm to 5 cm
B. 5 cm to 8 cm
C. 8 cm to 10 cm
D. 12 cm to 15 cm - The breadth of a ribbed slab containing two bars must be between______________?
A. 6 cm to 7.5 cm
B. 8 cm to 10 cm
C. 10 cm to 12 cm
D. 12 cm to 15 cm - A ribbed slab is provided for______________?
A. A plain ceiling
B. Thermal insulation
C. Acoustic insulation
D. All the above - on a circular slab of radius , the maximum radial moment at the centre of the If is the load slab, is WR²/16_____________?
A. 2WR²/16
B. 3WR²/16
C. 5WR²/16
D> NON OF THESE - If W is the load on a circular slab of radius R, the maximum circumferential moment at the centre of the slab, is________________?
A. WR²/16
B. 2WR²/16
C. 3WR²/16
D. Zero - bending moment of a simply supported slab is M Kg.cm, the effective depth of the If the maximum slab is (where Q is M.R. factor)________________?
A. M/100Q
B. M/ Q
C. M/Q)
D. (M/100Q) - The minimum thickness of the cover at the end of a reinforcing bar should not be less than twice the diameter of the bar subject to a minimum of___________________?
A. 10 mm
B. 15 mm
C. 20 mm
D. 25 mm - The length of the lap in a compression member is kept greater than bar diameter x (Permissible stress in bar / Five times the bond stress) or____________________?
A. 12 bar diameters
B. 18 bar diameters
C. 24 bar diameters
D. 30 bar diameters - If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than________________?
A. WL/12 (L – 2D/3)²
B. WL/10 (L + 2D/3)²
C. WL/10 (L – 2D/3)²
D. WL/12 (L – D/3)² - If K is a constant depending upon the ratio of the width of the slab to its effective span l, x is the distance of the concentrated load from the nearer support, bw is the width of the area of contact of the concentrated load measured parallel to the supported edge, the effective width of the slab be is_______________?
A. K/x (1 + x/d) + bw
B. Kx (1 – x/l) + bw
C. Kx (1 + x/l) + bw
D. All the above
