A. WR²/16
B. 2WR²/16
C. 3WR²/16
D. Zero
Related Mcqs:
- on a circular slab of radius , the maximum radial moment at the centre of the If is the load slab, is WR²/16_____________?
A. 2WR²/16
B. 3WR²/16
C. 5WR²/16
D> NON OF THESE - If is the uniformly distributed load on a circular slab of radius maximum positive radial moment at its centre, is__________________?
A. 3WR²/16
B. 2WR²/16
C. WR²/16
D. None of these - For a circular slab carrying a uniformly distributed load, the ratio of the maximum negative to maximum positive radial moment, is___________________?
A. 1
B. 2
C. 3
D. 5 - If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than________________?
A. WL/12 (L – 2D/3)²
B. WL/10 (L + 2D/3)²
C. WL/10 (L – 2D/3)²
D. WL/12 (L – D/3)² - bending moment of a simply supported slab is M Kg.cm, the effective depth of the If the maximum slab is (where Q is M.R. factor)________________?
A. M/100Q
B. M/ Q
C. M/Q)
D. (M/100Q) - To ensure that the hogging bending moment at two points of suspension of a pile of length L equals the sagging moment at its centre, the distances of the points of suspension from either end, is________________?
A. 0.107 L
B. 0.207 L
C. 0.307 L
D. 0.407 L - If K is a constant depending upon the ratio of the width of the slab to its effective span l, x is the distance of the concentrated load from the nearer support, bw is the width of the area of contact of the concentrated load measured parallel to the supported edge, the effective width of the slab be is_______________?
A. K/x (1 + x/d) + bw
B. Kx (1 – x/l) + bw
C. Kx (1 + x/l) + bw
D. All the above - If depth of slab is 10 cm, width of web 30 cm, depth of web 50 cm, centre to centre distance of beams 3 m, effective span of beams 6 m, the effective flange width of the beam, is________________?
A. 200 cm
B. 300 cm
C. 150 cm
D. 100 cm - In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed________________?
A. 10 mm
B. 15 mm
C. 20 mm
D. 25 mm - carrying a uniformly distributed load per metre length is suspended at the A pile of length centre and from other two points 0.15 L from either end ; the maximum hogging moment will be_______________?
A. WL²/15
B. WL²/30
C. WL²/60
D. WL²/90
