A. 90° and 0°
B. 75° and 30°
C. 60° and 10°
D. 40° and 25°
Advertisement
Related Mcqs:
- Higher pitch of the roof (1) results in stronger roof (2) results in weaker roof (3) requires more covering material (4) requires less covering material The correct answer is___________?
- A. (1) and (3) B. (1) and (4) C. (2) and (3) D. (2) and (4)...
- The pressure acting on the stones in stone masonry construction should be_____________?
- A. along the direction of bedding planes B. at 45° to the direction of bedding planes C. at 60° to the direction of bedding planes D. perpendicular to the direction of bedding planes...
- As compared to stretcher course, the thickness of joints in header course should be_____________?
- A. less B. more C. equal D. equal or more...
- Which of the following pairs gives a correct combination of the useful and harmful constituents respectively of a good brick earth ?
- A. lime stone and alumina B. silica and alkalies C. alumina and iron D. alkalies and magnesium...
- Minimum thickness of wall where single flemish bond can be used is_____________?
- A. half brick thick B. one brick thick C. one and a half bricks thick D. two bricks thick...
- The minimum depth of foundation in clayey soils is_______________?
- A. 0.5 m B. 0.7 m C. 0.9 m D. 1.2 m...
- Minimum width of landing should be_______________?
- A. equal to width of stairs B. half the width of stairs C. twice the width of stairs D. one fourth the width of stairs...
- In which of the following directions, the strength of timber is maximum ?
- A. parallel to grains B. 45° to grains C. perpendicular to grains D. same in all directions...
- As per IS specifications, the maximum final setting time for ordinary Portland cement should be_______________?
- A. 30 minutes B. 1 hour C. 6 hours D. 10 hours...
- Which of the following cements contains maximum percentage of dicalcium silicate?
- A. ordinary Portland cement B. low heat cement C. rapid hardening cement D. sulphate resisting cement...
Advertisement
