A. Same elevation in boiling point
B. Different elevation in boiling point
C. Elevation in boiling point in the ratio of their molecular weights
D. None of these
Related Mcqs:
- The vapor pressure of the solvent decreased by 10 mm Hg, when a non-volatile solute was added to the solvent. The mole fraction of the solute in the solution is 0.2. What should be the mole fraction of the solvent, if the decrease in vapor pressure of the solvent is required to be 20 mm Hg ?
A. 0.2
B. 0.1
C. 0.4
D. 0.6 - The vapour pressure of a solution (made by dissolving a solute in a solvent) is ____________ that of the pure solvent?
A. Less than
B. More than
C. Equal to
D. Either more or less; depends on the solvent - A solution is made by dissolving 1 kilo mole of solute in 2000 kg of solvent. The molality of the solution is_________________?
A. 2
B. 1
C. 0.5
D. 0.05 - A very dilute solution is prepared by dissolving ‘x1’ mole of solute in ‘x2’ mole of a solvent. The mole fraction of solute is approximately equal to_________________?
A. x1/x2
B. x2/x1
C. 1 – (x1/x2)
D. 1/x2 - Osmotic pressure exerted by a solution prepared by dissolving one gram mole of a solute in 22.4 litres of a solvent at 0°C will be _______________ atmosphere?
A. 0.5
B. 1
C. 1.5
D. 2 - Dissolving a solute in a solvent does not change its________________?
A. Specific heat
B. Vapour pressure
C. Viscosity
D. None of these - 80 kg of Na2SO4 (molecular weight = 142) is present in 330 kg of an aqueous solution. The solution is cooled such that. 80 kg of Na2SO4 .10H2O crystals separate out. The weight fraction of Na2SO4 in the remaining solution is_________________?
A. 0.00
B. 0.18
C. 0.24
D. 1.00 - Addition of a non-volatile solute to a solvent produces a ______________ in its solvent?
A. Freezing point elevation
B. Boiling point depression
C. Vapor pressure lowering
D. All A., B. & C. - If the partial pressure of the solvent in the vapor phase is equal to the vapor pressure of the solvent at that temperature, then the system is said to be at its___________________?
A. Bubble point
B. Saturation temperature
C. Dew point
D. Both B. and C. - The boiling points for pure water and pure toluene are 100°C and 110.6°C respectively. Toluene and water are completely immiscible in each other. A well agitated equimolar mixture of toluene and water are prepared. The temperature at which the above mixture will exert a pressure of one standard atm. is___________________?
A. Less than 100°C
B. 100°C
C. Between 100 and 110°C
D. 110.6°C
Advertisement