A. Primary
B. Intermediate
C. Fine
D. Ultrafine
Related Mcqs:
- Crushing of mineral particles is accomplished in a ‘cage mill’, when one or more alloy steel bars are revolved in opposite directions. It is a type of ______________ mill?
A. Impact
B. Roll
C. Vibratory
D. None of these - In a ball mill, the volume occupied by the balls (when the mill is stopped) is about _______________ percent of the volume of the mill?
A. 35
B. 50
C. 70
D. 85 - The main differentiation factor between tube mill and ball mill is the ___________________?
A. Length to diameter ratio
B. Size of the grinding media
C. Final product size
D. Operating speed - In a size reduction crushing operation, feed size is 300 to 1500 mm while the product size is 100 to 300 mm. This is a case of the ________________ crushing?
A. Secondary
B. Fine
C. Primary
D. Ultrafine - In a size reduction crushing operation, feed size is 100 to 300 mm. while the product size is 10 to 50 mm. This is a case of the _____________ crushing?
A. Primary
B. Secondary
C. Fine
D. Ultrafine - General crushing equation is given by d(P/m) = -K (dD̅ S/D̅ n S). Bond’s crushing law is obtained by solving this equation for n = _____________ and feed of infinite size?
A. 1
B. 1.5
C. 2
D. 2.5 - In a size reduction crushing operation, the feed size is 10 to 50 mm, while the product size is 2 to 10 mm. This is a case of _______________ crushing?
A. Primary
B. Secondary
C. Fine
D. Ultrafine - What is the usual value of angle of nip for crushing of ordinary rock in smooth steel crushing rolls?
A. 16°
B. 32°
C. 40°
D. 46° - For crushing of solids, the Rittinger’s law states that the work required for crushing is proportional to __________________?
A. The new surface created
B. The size reduction ratio
C. The change in volume due to crushing
D. None of these - Power required to drive a ball mill with a particular ball load is proportional to (where, D = diameter of ball mill.) ?
A. D
B. 1/D
C. D2.5
D. 1/D2.5
