General crushing equation is given by d(P/m) = -K (dD̅ S/D̅ n S). Bond’s crushing law is obtained by solving this equation for n = _____________ and feed of infinite size?

Related Mcqs:

1. In a size reduction crushing operation, feed size is 100 to 300 mm. while the product size is 10 to 50 mm. This is a case of the _____________ crushing?

   A. Primary
   B. Secondary
   C. Fine
   D. Ultrafine

2. Which of the following equations is Rittinger’s crushing law? (Where P = power required by the machine, m = feed rate, k = a constant, D̅ sa & D̅ sb = volume surface mean diameter of feed & product respectively) ?

   A. P/m = K/ √Dp
   B. P/m = K . ln D̅ sa/D̅ sb
   C. P/m = K . (1/ D̅ sb – 1/D̅ sa)
   D. None of these

3. According to Bond crushing law, the work required to form particle of size ‘D’ from very large feed is (where (S/V)p and (S/V)f are surface to volume ratio of the product and feed respectively) ?

   A. (S/V)p
   B. √(S/V)p
   C. (S/V)2p
   D. (S/V)f

4. In a size reduction crushing operation, feed size is 300 to 1500 mm while the product size is 100 to 300 mm. This is a case of the ________________ crushing?

   A. Secondary
   B. Fine
   C. Primary
   D. Ultrafine

5. In a size reduction crushing operation, the feed size is 10 to 50 mm, while the product size is 2 to 10 mm. This is a case of _______________ crushing?

   A. Primary
   B. Secondary
   C. Fine
   D. Ultrafine

6. For crushing of solids, the Rittinger’s law states that the work required for crushing is proportional to __________________?

   A. The new surface created
   B. The size reduction ratio
   C. The change in volume due to crushing
   D. None of these

7. The basic filtration equation is given as dt/dV = (μ/A ΔP). [(α .CV/A) + Rm], where, V is volume of the filtrate; A is the filtration area, a is specific cake resistance, μ is viscosity of the filtrate, and C is the concentration of the solids in the feed slurry. In a 20 minutes constant rate filtration, 5 m3 of filtrate was obtained. If this is followed by a constant pressure filtration, how much more time in minutes, it will take for another 5 m3 of filtrate to be produced? Neglect filter medium resistance, Rm; assume incompressible cake ?

   A. 10
   B. 20
   C. 25
   D. 30

8. The constants (Kb, Kr and Kk) used in the laws of crushing (i.e., Bond’s law, Rittinger’s law and Kick’s law) depend upon the_________________?

   A. Feed material
   B. Type of crushing machine
   C. Both A. & B.
   D. Neither A. nor B.

9. Half the angle of nip, (α), for a roll crusher is given by (where, dr, dp and df are diameters of crushing rolls, feed particles and rolls gap respectively) ?

   A. cos α = (dr + dp)/(dr + df)
   B. cos α = (dr + df)/(dr + dp)
   C. tan α = (dr + dp)/(dr + df)
   D. sin α = (dr + dp)/(dr + df)

10. What is the usual value of angle of nip for crushing of ordinary rock in smooth steel crushing rolls?

    A. 16°
    B. 32°
    C. 40°
    D. 46°