A. 3.6 W.D.V.ρ
B. 3.6 W.D.V
C. 3.6 W.V.ρ
D. 3.6 D.V.ρ
Related Mcqs:
- Theoretical capacity of crushing rolls in tons/hr is given by (where, V = peripheral velocity, m/sec. W = width of rolls, m Dr = distance between rolls ρ = density of material to be crushed, kg/m3 here, V =πND where, N = speed of the rolls in rotation per second (rps) D = diameter of rolls, m) ?
A. 3.6 V.W.Dr.ρ
B. 3.6 V.W. ρ
C. 3.6 W.Dr.ρ
D. 3.6 V.W.Dr/ρ - Width and speed of a conveyor belt depends upon the ______________ of the material?
A. Lump size
B. Bulk density
C. Both A. & B.
D. Neither A. nor B. - The capacity of a classifier in ‘tons of solid/hr’ is given by (where, A = cross-sectional area in m2, V = rising velocity of fluid in m/sec, S = percentage of solids in the suspension by volume, ρ = density of solids in kg/m3)_________________?
A. 3.6 AVS.ρ
B. 3.6 A.V.ρ
C. 3.6 A.S. ρ
D. 3.6 AVS/ρ
Answer: Option - Capacity (in tons/hr) of jaw/gyratory crusher is equal to (where, L = length of the receiving opening, cm S = greater width of the discharge opening, cm) ?
A. 0.01 L.S
B. 0.087 L.S
C. L.S
D. L.S/0.087 - Critical speed of rotation, N (in rps – rotation per second) of a trammel is equal to (where, g = acceleration due to gravity = 9.81 m/sec2 and, r = radius of trammel, metre.) ?
A. (1/2π). √(g/r)
B. (1/π). √(g/r)
C. ½ √(g/r)
D. 2π. √(g/r) - The capacity of a belt conveyor depends upon two factors. If one is the cross-section of the load, the other is the _____________ of the belt?
A. Speed
B. Thickness
C. Length
D. None of these - Vibrating screens have capacity in the range of ______________ tons/ft2 .mm mesh size?
A. 0.2 to 0.8
B. 5 to 25
C. 50 to 100
D. 100 to 250 - Which is the most suitable conveyor for transportation of sticky material ?
A. Apron conveyor
B. Belt conveyor
C. Screw conveyor
D. Pneumatic conveyor - Actual operating speed of a ball mill may vary from 65 to 80% of the critical speed. Which of the following duties would require the ball mill to be operated at maximum percentage of critical speed ?
A. Wet grinding in low viscous suspension
B. Wet grinding in high viscous suspension
C. Dry grinding of large particles (upto 1.25 cms)
D. Dry grinding of large particles in un-baffed mills - Critical Speed (Nc) of a ball mill is given by (where R1 and R2 are radii of ball mill and the ball respectively) ?
A. Nc = (1/4π). √(g/R1 – R2)
B. Nc = (1/2π). √(g/R1 – R2)
C. Nc = (1/π). √(g/R1 – R2)
D. Nc = (1/2π). √(R1 – R2/g)
