A. Run upto 1 km
B. Travel at a speed upto 300 metres/minute
C. Handle materials upto 5000 tons/hr
D. All A., B. and C.
Related Mcqs:
- The capacity of a belt conveyor depends upon two factors. If one is the cross-section of the load, the other is the _____________ of the belt?
A. Speed
B. Thickness
C. Length
D. None of these - ____________ conveyor is the most suitable for long distance transportation of cold, nonabrasive granular/irregular shape/fine materials?
A. Bucket
B. Belt
C. Screw
D. Apron - __________ conveyor is the most suitable for short distance transportation of non-abrasive loose materials like garbage, grain, food wastes etc?
A. Flight
B. Screw
C. Drag
D. Belt - Capacity of flight conveyor in tons/hr is given by (where, W & D = width and depth of flight respectively in metre V = speed of the conveyor, metre/second ρ = bulk density of material, kg/m3) ?
A. 3.6 W.D.V.ρ
B. 3.6 W.D.V
C. 3.6 W.V.ρ
D. 3.6 D.V.ρ - Which is the most suitable conveyor for transportation of sticky material ?
A. Apron conveyor
B. Belt conveyor
C. Screw conveyor
D. Pneumatic conveyor - Short distance transportation of grain, gravel, sand, ash, asphalt etc. is done by using a ______________ conveyor?
A. Flight
B. Slat or drag
C. Ribbon
D. Screw - For the transportation of ultrafine particles, the equipment used is a ____________ conveyor?
A. Belt
B. Pneumatic
C. Screw
D. None of these - Width and speed of a conveyor belt depends upon the ______________ of the material?
A. Lump size
B. Bulk density
C. Both A. & B.
D. Neither A. nor B. - The maximum slope of a belt conveyor can be_____________________?
A. 15°
B. 30°
C. 45°
D. 60° - Hot, lumpy & abrasive materials are best transported by using a/an ___________ conveyor ?
A. Apron
B. Belt
C. Screw
D. Flight
