Related Mcqs:

1. Walls of a cubical oven are of thickness l, and they are made of material of thermal conductivity k. The temperature inside the oven is 100°C and the inside heat transfer coefficient is „3k/l’. If the wall temperature on the outside is held at 25°C, what is the inside wall temperature in degree centigrade ?

   A. 35.5
   B. 43.75
   C. 81.25
   D. 48.25

2. A wall has two layers of materials A and B; each made of a different material. Both the layers have the same thickness. The thermal conductivity of material A is twice that of B. Under the equilibrium, the temperature difference across the wall is 36°C. The temperature difference across the layer A is ______________ °C?

   A. 6
   B. 12
   C. 18
   D. 24

3. A composite flat wall of a furnace is made of two materials ‘A’ and ‘B’. The thermal conductivity of ‘A’ is twice of that of material ‘B’, while the thickness of layer of ‘A’ is half that of B. If the temperature at the two sides of the wall are 400 and 1200°K, then the temperature drop (in °K) across the layer of material ‘A’ is________________?

   A. 125
   B. 133
   C. 150
   D. 160

4. A composite wall consists of two plates A and B placed in series normal to the flow of heat. The thermal conductivities are kA and kB and the specific heat capacities are CPA and CPB for plates A and B respectively. Plate B has twice the thickness of plate A. At steady state, the temperature difference across plate A is greater than that across plate B, when_________________?

   A. CPA > CPB
   B. CPA < CPB
   C. kA < 0.5 kB
   D. kA >2 kB

5. A 10 cm dia steam pipe, carrying steam at 180°C, is covered with an insulation (conductivity = 0.6 W/m.°C). It losses heat to the surroundings at 30°C. Assume a heat transfer co-efficient of 0.8 W/m2.°C for heat transfer from surface to the surroundings. Neglect wall resistance of the pipe and film resistance of steam. If the insulation thickness is 2 cms, the rate of heat loss from this insulated pipe will be__________________?

   A. Greater than that for un-insulated steam pipe
   B. Less than that of the un-insulated steam pipe
   C. Equal to that of the un-insulated steam pipe
   D. Less than the steam pipe with 5 cms insulation

6. If the thermal conductivity of a wall material is independent of temperature, the steady state temperature distribution in the very large thin plane wall having steady, uniform surface temperature follows _____________ law?

   A. Parabolic
   B. Hyperbolic
   C. Linear
   D. Logarithmic

7. If the thermal conductivity of a wall material is independent of temperature, the steady state temperature distribution in the very large thin plane wall having steady, uniform surface temperature follows ____________ law?

   A. Hyperbolic
   B. Parabolic
   C. Linear
   D. Logarithmic

8. The inner wall of a furnace is at a temperature of 700°C. The composite wall is made of two substances, 10 and 20 cm thick with thermal conductivities of 0.05 and 0.1 W.m-1.°C- 1 respectively. The ambient air is at 30°C and the heat transfer co-efficient between the outer surface of wall and air is 20 W.m-2.°C-1. The rate of heat loss from the outer surface in W.m-2is__________________?

   A. 165.4
   B. 167.5
   C. 172.5
   D. 175

9. Three materials A, B and C of equal thickness and of thermal conductivity of 20, 40 & 60 kcal/hr. m. °C respectively are joined together. The temperature outside of A and C are 30°C and 100°C respectively. The interface between B and C will be at a temperature of ____________ °C?

   A. 40
   B. 95
   C. 70
   D. 50

10. The variation of thermal conductivity of a metal with temperature is often correlated using an expression of the form K = K0 + at, where, K is the thermal conductivity and T is the temperature (in °K). The units of ‘a’ in SI system will be________________?

    A. W/m.k
    B. W/m
    C. W/m.k2
    D. None, ‘a’ is just a number