Evaporator tubes are generally_____________________?

Related Mcqs:

1. Tubes are held between top and bottom tube sheets in Calandria type evaporator by keeping_________________?

   A. Both the tube sheets fixed
   B. Both the tube sheets floating
   C. The top tube sheet floating and bottom tube sheet fixed
   D. The top tube sheet fixed and the bottom tube-sheet floating

2. A multiple effect evaporator as compared to a single effect evaporator of the same capacity has _________________?

   A. Lower heat transfer area
   B. Lower steam economy
   C. Higher steam economy
   D. Higher solute concentration in the product

3. In a single evaporator system, the steam economy ________________ by creating vacuum in the evaporator?

   A. Increases
   B. Decreases
   C. Remain constant
   D. May increase or decrease, depends on the vacuum

4. It is desired to concentrate a 20% salt solution (20 kg of salt in 100 kg of solution) to a 30% salt solution in an evaporator. Consider a feed of 300 kg/min at 30°C. The boiling point of the solution is 110°C, the latent heat of vaporisation is 2100 kJ/kg and the specific heat of the solution is 4 kJ/kg.K. The rate at which the heat has to be supplied in (kJ/min) to the evaporator is____________________?

   A. 3.06 × 105
   B. 6.12 × 105
   C. 7.24 × 105
   D. 9.08 × 105

5. A dilute aqueous solution is to be concentrated in an evaporator system. High pressure steam is available. Multiple effect evaporator system is employed, because__________________?

   A. Total heat transfer area of all the effects is -less than that in a single effect evaporator system
   B. Total amount of vapor produced per Kg of feed steam in a multiple effect system is much
   higher than in a single effect
   C. Boiling point elevation in a single effect system is much higher than that in any effect in a
   multi-effect system
   D. Heat transfer co-efficient in a single effect is much lower than that in any effect in a multieffect
   system

6. For the same heat transfer area and the terminal conditions, the ratio of the capacities of a single effect evaporator to a triple effect evaporator is_________________?

   A. 3
   B. 0.33
   C. 1
   D. 1.33

7. For concentrating an aqueous solution of a material like anhydrous Na2SO4, whose solubility decreases with rise in temperature, the most suitable evaporator is a _______________ evaporator?

   A. High pressure
   B. Vacuum
   C. Backward feed
   D. None of these

8. Steam consumption in kg/hr in case of an evaporator is given by (where, C & E are capacity the economy of the evaporator respectively) ?

   A. C/E
   B. E/C
   C. CE
   D. 1/CE

9. Condensing film co-efficient for steam on horizontal tubes ranges from 5000 to 15000 Kcal/hr.m2.°C. Condensation of vapor is carried out inside the tube in a shell and tube heat exchanger, when the_________________?

   A. Higher condensing film co-efficient is desired
   B. Condensate is corrosive in nature
   C. Lower pressure drop through the exchanger is desired
   D. Temperature of the incoming vapor is very high

10. If all the conditions and dimensions are same, then the ratio of velocity through the tubes of a double pass heat exchanger to that through the single pass heat exchanger is_________________?

    A. 1
    B. 2
    C. 1/2
    D. 4