A. Heat release rate of the fuel
B. Preheat temperature of fuel & air
C. Method of mixing the fuel & air
D. All A., B. and C.
Related Mcqs:
- Combustion of furnace oil in a furnace (soaking pit) with preheated combustion air at 400°C results in saving of about __________ percent furnace oil as compared to its combustion with atmospheric air, if the flue gas outlet temperature from the soaking pit is 1200°C ?
A. 5
B. 60
C. 20
D. 40 - In a furnace, the heat taken by the charge/stock and the heat lost to the furnace structure & flue gases depends on the__________________?
A. Rate of firing and emissivity of flame
B. Thermal conductivity of the charge & structural materials of furnace
C. Nature of process; whether batch, continuous or intermittent
D. All A., B. and C. - Design of waste heat boiler for recovery of waste heat from furnace gases depends upon the_________________?
A. Quantity & temperature of waste gas
B. Dust concentration & nature of dust in waste gas
C. Corrosive nature of the waste gas
D. All A., B. and C. - The rate of scaling of furnace stock depends upon the_________________?
A. Temperature
B. Time
C. Nature of atmosphere
D. All A., B. and C. - The amount of combustible escaping unconsumed from the furnace, depends upon the________________?
A. Air supplied and furnace temperature
B. Burner design (thoroughness of mixing versus stratification)
C. Air preheat and the flow of gases in the furnace (mixing by induction, by acceleration or by
change of direction)
D. All A., B. and C. - If the flame is produced under the hearth and then sweeps up into the heating chamber, this is called a/an ______________ furnace?
A. Sidefired
B. Underfired
C. Covered
D. Recirculating - Combustion of fuel in a furnace with oxygen enriched air results in higher__________________?
A. Flue gas volume
B. Flame temperature
C. Fuel consumption
D. Stack loss - Which of the following advantages is not associated with the use of preheated air for combustion of a fuel in the furnace ?
A. Increase in calorific value of the fuel
B. Increase in flame temperature
C. Reduction in scale losses
D. Saving in fuel consumption - Out of the following fuels used in a furnace exhausting flue gas at a temperature of 600°C, the percentage stack loss will be maximum in case of complete combustion of_________________?
A. Furnace oil with air
B. Furnace oil with oxygen
C. Blast furnace gas with air
D. Blast furnace gas with oxygen - Furnace aerodynamics is related to the _____________ in the furnace?
A. Movement of gases
B. Measurement of flue gas volume
C. Temperature control
D. Pressure adjustment
