A. Flue gas volume
B. Flame temperature
C. Fuel consumption
D. Stack loss
Related Mcqs:
- Combustion of furnace oil in a furnace (soaking pit) with preheated combustion air at 400°C results in saving of about __________ percent furnace oil as compared to its combustion with atmospheric air, if the flue gas outlet temperature from the soaking pit is 1200°C ?
A. 5
B. 60
C. 20
D. 40 - Which of the following advantages is not associated with the use of preheated air for combustion of a fuel in the furnace ?
A. Increase in calorific value of the fuel
B. Increase in flame temperature
C. Reduction in scale losses
D. Saving in fuel consumption - Oxygen percentage in the flue gas coming out of a gaseous fuel fired furnace should be ideally about _____________ percent?
A. < 2
B. < 5
C. < 8
D. < 10 - An improved and fuel efficient version of the pusher type reheating furnace is the ______________ furnace?
A. Walking beam
B. Shaft
C. Tunnel
D. Rotary hearth - While the fuel fired furnace can be used upto a maximum temperature of about 1700°C, the electric furnace can be used upto a temperature of about _____________ °C?
A. 2000
B. 3000
C. 4500
D. 6000 - Higher furnace temperature cannot be achieved by use of a lean fuel gas in the furnace by_________________?
A. Increasing the draft in the furnace
B. Preheating the fuel gas
C. Oxygen enrichment of combustion air
D. Preheating the combustion air - Size of the combustion chamber of a furnace depends upon the ___________________?
A. Heat release rate of the fuel
B. Preheat temperature of fuel & air
C. Method of mixing the fuel & air
D. All A., B. and C. - Out of the following fuels used in a furnace exhausting flue gas at a temperature of 600°C, the percentage stack loss will be maximum in case of complete combustion of_________________?
A. Furnace oil with air
B. Furnace oil with oxygen
C. Blast furnace gas with air
D. Blast furnace gas with oxygen - Acid dew point temperature (ADT) of a flue gas produced by the combustion of a fuel containing 1% sulphur may be about ____________ °C?
A. 80
B. 130
C. 180
D. 250 - In practical operation of any furnace, zero oxygen percentage or theoretical CO2 percentage in flue gas is rarely achieved, because of__________________?
A. Use of non-preheated combustion air
B. Use of pulverised solid fuels
C. Imperfect mixing of fuel & air and infiltration of air
D. Use of excessive positive draft in the furnace
