Steam is intermittently admitted into the fuel bed during the production of producer gas to__________________?

Related Mcqs:

1. Explosion limit of blast furnace gas is 37 to 71% gas in gas-air mixture. It means that the blast furnace gas will explode when burnt in a confined space, if its concentration in the gas-air mixture is _______________ percent?

   A. 71%
   C. In between 37 & 71%
   D. None of these

2. Gasification of the solid fuel converts its organic part into combustible by interaction with air/oxygen and steam so as to obtain a secondary gaseous fuel of high calorific value having no ash. Gasification reactions are normally carried out at about _____________ °C?

   A. 400-500
   B. 900-1000
   C. 1400-1500
   D. 1700-1800

3. Which of the following is unsuitable fuel for producer gas manufacture ?

   A. Coke
   B. Anthracite
   C. Coal having low fusion point of its ash
   D. Coal having high fusion point of its ash

4. White flue gas (resembling steam) coming out of the chimney of a thermal power plant indicates that the fuel used in the boiler furnace is_________________?

   A. Tar
   B. Coke oven gas
   C. Pitch
   D. Pulverised coke

5. White flue gas (resembling steam) coming out of the chimney of a thermal power plant indicates that the fuel used in the boiler furnace is_______?

   A. Tar
   B. Sulphide Coke
   C. Coke Oven Gas
   D. Pulverised coke

   Submitted by: Muhammad Mutsadiq Umer

6. For the case of a fuel gas undergoing combustion with air, if the air/fuel ratio is increased, the adiabatic flame temperature will_____________________?

   A. Increase
   B. Decrease
   C. Increase or decrease depending on the fuel type
   D. Not change

7. Coke oven gas is a better fuel than blast furnace gas, because of its higher________________?

   A. Calorific value, cleanliness and relatively low distribution cost (due to its low specific gravity)
   B. Adiabatic flame temperature
   C. Heat release rate (thus requiring smaller combustion chamber)
   D. All A., B. and C.

8. Atomising steam to fuel oil ratio in a burner should be around__________________?

   A. 0.5
   B. 1.5
   C. 2.5
   D. 3.5

9. Theoretical flame temperature of a fuel is that temperature which is attained, when the fuel is completely burnt ‘using theoretical amount of air in___________________?

   A. Air
   B. Oxygen
   C. Either A. or B.
   D. Either A. or B. without gain or loss of heat

10. For which pair of the fuel gases, calorific value (C.V.) of one fuel is almost double that of the other on volume basis (i.e., kcal/Nm3), while the C.V. is same on weight basis (i.e., kcal/kg) ?

    A. Propane and acetylene
    B. Propane and LPG
    C. Sewage gas and gobar gas
    D. B.F. gas and coke oven gas