A. Increase
B. Decrease
C. Increase or decrease depending on the fuel type
D. Not change
Related Mcqs:
- The maximum adiabatic flame temperature in air is _____________ the maximum flame temperature in pure oxygen?
A. Lower than
B. Higher than
C. Same as
D. Not related to - Actual flame temperature is always lower than the adiabatic flame temperature, because there is________________?
A. No possibility of obtaining complete combustion at high temperature
B. Always loss of heat from the flame
C. Both A. and B.
D. Neither A. nor B. - Theoretical flame temperature of a fuel is that temperature which is attained, when the fuel is completely burnt ‘using theoretical amount of air in___________________?
A. Air
B. Oxygen
C. Either A. or B.
D. Either A. or B. without gain or loss of heat - Adiabatic flame temperature of a fuel is dependent on the initial temperature of___________________?
A. Fuel
B. Air
C. Both A. & B.
D. Neither A. nor B. - The ratio of maximum adiabatic flame temperature in air to that in pure oxygen is always___________________?
A. 1
B. < 1
C. > 1
D. Unpredictable - The maximum adiabatic flame temperature is attained, when the fuel is burnt with ______________________?
A. Theoretically required amount of air
B. More than theoretically required amount of air
C. Less than theoretically required amount of air
D. Theoretically required amount of oxygen - If the specific heat of gaseous products of combustion of a fuel is high, the abiabatic flame temperature will be_____________?
A. Low
B. High
C. Very high, if the fuel is of low calorific value
D. None of these - The maximum adiabatic flame temperature in air as compared to that in pure oxygen is_______________?
A. Much lower
B. Much higher
C. Same
D. Either lower or higher, depends on the type of fuel - Explosion limit of blast furnace gas is 37 to 71% gas in gas-air mixture. It means that the blast furnace gas will explode when burnt in a confined space, if its concentration in the gas-air mixture is _______________ percent?
A. 71%
C. In between 37 & 71%
D. None of these - Which of the following is not increased by using preheated combustion air in place of ordinary air at room temperature ?
A. Calorific value of the fuel
B. Flame temperature achieved
C. Speed of combustion of fuel
D. Heat transfer rate to the stock in the furnace