A. Turbine
B. Piston
C. Diaphragm
D. None of these
Related Mcqs:
- A centrifugal pump is used to pump water through a horizontal distance of 150 m, and then raised to an overhead tank 10 m above. The pipe is smooth with an I.D of 50 mm. What head (m of water) must the pump generate at its exit E. to deliver water at a flow rate of 0.001 m3/s? The Fanning friction factor, f is 0.0062 ?
A. 10 m
B. 11 m
C. 11.8 m
D. 30 m - A centrifugal pump used to pump water is used to pump an oil with specific gravity of 0.8 at the same rate. The power consumption will now_________________?
A. Increase
B. Decrease
C. Remain same
D. Data insufficient to predict - A centrifugal pump designed to pump water is employed to pump a more viscous oil. In the later case, the pump_________________?
A. Develops a lower head
B. Capacity is reduced
C. Requires more power
D. All A., B. and C. - A double acting reciprocating pump compared to a single acting pump (of almost same size working under same pressure levels) would give almost double___________________?
A. Head
B. Discharge
C. Efficiency
D. None of these - Higher specific speed (200-500) of a centrifugal pump indicates that the pump is of ______________ flow type?
A. Axial
B. Radial
C. Mixed
D. None of these - Consider a centrifugal pump having a specific impeller diameter, fixed impeller speed pumping a liquid of constant density at a particular discharge capacity. With decrease in the capacity of the pump, the _______________ decreases?
A. NPSH required
B. BHP required by the pump
C. Head of the liquid pumped
D. All A., B. and C. - In case of unsteady fluid flow, conditions & flow pattern change with the passage of time at a position in a flow situation. Which of the following is an example of unsteady flow ?
A. Discharge of water by a centrifugal pump being run at a constant rpm
B. Water flow in the suction and discharge pipe of a reciprocating pump
C. Water discharge from a vertical vessel in which constant level is maintained
D. Low velocity flow of a highly viscous liquid through a hydraulically smooth pipe - Bernoulli’s equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli’s equation? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible ?
A. A, C, D
B. B, D, E
C. A, B, E
D. A, D, E - While starting an axial flow pump, its delivery valve should be kept _______________?
A. Open
B. Closed
C. Either open or closed
D. None of these - High specific speed of a pump implies that, it is a/an _____________ pump?
A. Centrifugal
B. Mixed flow
C. Axial flow
D. None of these
