A double acting reciprocating pump compared to a single acting pump (of almost same size working under same pressure levels) would give almost double___________________?

Related Mcqs:

1. At what value of crank angle (roughly), no flow of water from or into the air vessel takes place in case of a double acting reciprocating pump ?

   A. 40° and 140°
   B. 45° and 60°
   C. 90° and 80°
   D. 20° and 120°

2. A centrifugal pump is used to pump water through a horizontal distance of 150 m, and then raised to an overhead tank 10 m above. The pipe is smooth with an I.D of 50 mm. What head (m of water) must the pump generate at its exit E. to deliver water at a flow rate of 0.001 m3/s? The Fanning friction factor, f is 0.0062 ?

   A. 10 m
   B. 11 m
   C. 11.8 m
   D. 30 m

3. A centrifugal pump used to pump water is used to pump an oil with specific gravity of 0.8 at the same rate. The power consumption will now_________________?

   A. Increase
   B. Decrease
   C. Remain same
   D. Data insufficient to predict

4. A centrifugal pump designed to pump water is employed to pump a more viscous oil. In the later case, the pump_________________?

   A. Develops a lower head
   B. Capacity is reduced
   C. Requires more power
   D. All A., B. and C.

5. Purpose of relief valve in a reciprocating pump is to___________________?

   A. Protect the pump against developing excessive pressure
   B. Facilitate unidirectional flow of liquid
   C. Reduce the discharge pressure
   D. Control the rate of discharge

6. What is the maximum theoretical suction lift (metres) of a reciprocating pump ?

   A. 5
   B. 10
   C. 50
   D. 100

7. Air vessel of a reciprocating pump is initially filled with___________________?

   A. Atmospheric air
   B. Compressed air
   C. Water
   D. None of these

8. Function of air vessel provided in a reciprocating pump is to_________________?

   A. Reduce discharge fluctuation
   B. Reduce the danger of cavitation
   C. Avoid the necessity of priming
   D. Increase the pump efficiency

9. The percentage slip in a reciprocating pump set is given by the % of (where, Q1 = actual discharge Q2 = theoretical discharge) ?

   A. Q1/Q2
   B. Q2/Q1
   C. (Q2 – Q1)/Q1
   D. (Q2 – Q1)/Q2

10. For a reciprocating pump, the indicator diagram is the graph between the________________?

    A. Discharge and overall efficiency
    B. Volume swept by piston for one complete revolution and the pressure in the cylinder
    C. Angle swept by the crank pin at any instant and the discharge
    D. None of these