The most suitable flow measuring device for the fluid flow measurement in a very large diameter pipeline is a____________________?

Related Mcqs:

1. Bernoulli’s equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli’s equation? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible ?

   A. A, C, D
   B. B, D, E
   C. A, B, E
   D. A, D, E

2. Venturimeters, orificemeters and nozzles are used to measure the fluid discharge from a pipeline. The average fluid velocity in a pipeline can be measured by a/an________________?

   A. Weir
   B. Hot wire anemometer
   C. Cup and vane anemometer
   D. None of these

3. In which type of fluid flow, the velocity of flow of fluid changes from point to point in the fluid at any instant ?

   A. Rotational
   B. Unsteady
   C. Turbulent
   D. Non-uniform

4. ____________ is used for measuring the static pressure exerted on the wall by a fluid flowing parallel to the wall in a pipeline?

   A. Venturimeter
   B. Pressure gauge
   C. Pitot tube
   D. Orificemeter

5. In case of unsteady fluid flow, conditions & flow pattern change with the passage of time at a position in a flow situation. Which of the following is an example of unsteady flow ?

   A. Discharge of water by a centrifugal pump being run at a constant rpm
   B. Water flow in the suction and discharge pipe of a reciprocating pump
   C. Water discharge from a vertical vessel in which constant level is maintained
   D. Low velocity flow of a highly viscous liquid through a hydraulically smooth pipe

6. For laminar flow of a fluid through a packed bed of spheres of diameter d, the pressure drop per unit length of bed depends upon the sphere diameter as_________________?

   A. d
   B. d2
   C. d4
   D. d̅ 2

7. The fluid velocity varies as the square root of the cylindrical pipe diameter in case of steady state laminar flow at constant pressure drop of _____________ fluid?

   A. Dilatent
   B. Pseudo-plastic
   C. Bingham plastic
   D. Newtonian

8. The fluid velocity varies as the square of the cylindrical pipe diameter, in case of steady state laminar flow at constant pressure drop, for ______________ fluid?

   A. Newtonian
   B. Dilatant
   C. Pseudo-plastic

   D. Non-Newtonian

9. The fluid velocity varies as the cube of the cylindrical pipe diameter in case of steady state laminar flow at constant pressure drop for ____________ fluid?

   A. Newtonian
   B. Pseudo-plastic
   C. Dilatent
   D. Bingham plastic

10. For laminar flow of Newtonian fluids through a circular pipe, for a given pressure drop and length & diameter of pipe, the velocity of fluid is proportional to (where, μ = fluid viscosity ) ?

    A. μ
    B. 1/μ
    C. √μ
    D. 1/√μ