The fluid in which the shearing stress within it is proportional to the velocity gradient across the sheared section, is called a _____________ fluid?

Related Mcqs:

1. Bernoulli’s equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli’s equation? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible ?

   A. A, C, D
   B. B, D, E
   C. A, B, E
   D. A, D, E

2. A pipe has a porous section of length L as shown in the figure. Velocity at the start of this section of V0. If fluid leaks into the pipe through the porous section at a volumetric rate per unit area q(x/L)2, what will be axial velocity in the pipe at any „x‟? Assume incompressible one dimensional flow i.e., no gradients in the radial direction ?

   A. VX = V0 + q (x3/L2D)
   B. VX = V0 + ⅓q (x3/L2)
   C. VX = V0 + 2q (x2/LD)
   D. VX = V0 + (4/3) q (x3/L2D)

3. As per Newton’s law of viscosity, the shear stress for a given rate of angular deformation of fluid is proportional to (where, μ = fluid viscosity) ?

   A. 1/μ
   B. μ
   C. μ2
   D. 1/μ2

4. For laminar flow of Newtonian fluids through a circular pipe, for a given pressure drop and length & diameter of pipe, the velocity of fluid is proportional to (where, μ = fluid viscosity ) ?

   A. μ
   B. 1/μ
   C. √μ
   D. 1/√μ

5. A Bingham fluid of viscosity μ = 10 Pa.s and yield stress, η0 = 10 KPa, is shared between flat parallel plates separated by a distance of 10-3 m. The top plate is moving with a velocity of 1 m/s. The shear stress on the plate is________________?

   A. 10 KPa
   B. 20 KPa
   C. 30 KPa
   D. 40 KPa

6. In case of turbulent flow of a Newtonian fluid in a straight pipe, the maximum velocity is equal to (where, Vavg = average fluid velocity)?

   A. Vavg
   B. 1.2 Vavg
   C. 1.5 Vavg
   D. 1.8 Vavg

7. The ratio of average fluid velocity to the maximum velocity in case of laminar flow of a Newtonian fluid in a circular pipe is_____________________?

   A. 0.5
   B. 1
   C. 2
   D. 0.66

8. The pressure drop per unit length of pipe incurred by a fluid ‘X’ flowing through pipe is Δp. If another fluid ‘Y’ having both the specific gravity & density just double of that of fluid ‘X’, flows through the same pipe at the same flow rate/average velocity, then the pressure drop in this case will be__________________?

   A. Δp
   B. 2Δp
   C. Δp2
   D. Δp/2

9. In which type of fluid flow, the velocity of flow of fluid changes from point to point in the fluid at any instant ?

   A. Rotational
   B. Unsteady
   C. Turbulent
   D. Non-uniform

10. A fluid which has a linear relationship between the magnitude of applied shear-stress and the resulting rate of deformation is called a/an _____________ fluid?

    A. Newtonian
    B. Non-Newtonian
    C. Ideal
    D. Incompressible