Pascal law is not applicable for a/an ________________________ fluid?

Related Mcqs:

1. Bernoulli’s equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli’s equation? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible ?

   A. A, C, D
   B. B, D, E
   C. A, B, E
   D. A, D, E

2. Hydraulic _____________ works on the principle of Pascal’s law of transmission of fluid pressure?

   A. Press
   B. Turbine
   C. Pump
   D. Coupling

3. Pascal’s law is valid, only when the fluid is_____________________?

   A. Frictionless and at rest
   B. At rest
   C. At rest and when the frictionless fluid is in motion
   D. None of these

4. Which of the following must be followed by the flow of a fluid (real or ideal)? (I) Newton’s law of viscosity. (II) Newton’s second law of motion. (III) The continuity equation. (IV) Velocity of boundary layer must be zero relative to boundary. (V) Fluid cannot penetrate a boundary?

   A. I, II, III
   B. II, III, V
   C. I, II, V
   D. II, IV, V

5. The pressure drop per unit length of pipe incurred by a fluid ‘X’ flowing through pipe is Δp. If another fluid ‘Y’ having both the specific gravity & density just double of that of fluid ‘X’, flows through the same pipe at the same flow rate/average velocity, then the pressure drop in this case will be__________________?

   A. Δp
   B. 2Δp
   C. Δp2
   D. Δp/2

6. In which type of fluid flow, the velocity of flow of fluid changes from point to point in the fluid at any instant ?

   A. Rotational
   B. Unsteady
   C. Turbulent
   D. Non-uniform

7. As per Newton’s law of viscosity, the shear stress for a given rate of angular deformation of fluid is proportional to (where, μ = fluid viscosity) ?

   A. 1/μ
   B. μ
   C. μ2
   D. 1/μ2

8. In the Newton’s law range, the terminal velocity of a solid spherical particle falling through a stationary fluid mass is ______________ the fluid viscosity?

   A. Directly proportional to
   B. Inversely proportional to
   C. Inversely proportional to the square root of
   D. Independent of

9. One dimensional fluid flow implies the ________________________?

   A. Flow in straight lines only
   B. Uniform flow
   C. Steady uniform flow
   D. Flow in which transverse components are zero

10. Which law/principle of solid mechanics is similar/equivalent to Newton’s law of viscosity in fluid mechanics ?

    A. Archimedes principle
    B. Newton’s second law of motion
    C. Hooke’s law
    D. Newton’s third law of motion