A. Laminar
B. Unsteady
C. Steady
D. Uniform
Related Mcqs:
- Bernoulli’s equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli’s equation? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible ?
A. A, C, D
B. B, D, E
C. A, B, E
D. A, D, E - A 2″ gate valve fitted in a pipe is replaced by a similar globe valve. Pressure drop in gate valve was Δp. For the same discharge, the pressure drop across globe valve is__________________?
A. Δp
B. < Δp
C. > Δp
D. Δp2 - Venturimeters, orificemeters and nozzles are used to measure the fluid discharge from a pipeline. The average fluid velocity in a pipeline can be measured by a/an________________?
A. Weir
B. Hot wire anemometer
C. Cup and vane anemometer
D. None of these - For the same terminal conditions and valve size, the pressure drop in a fully opened globe valve as compared to that in a gate valve is___________________?
A. More
B. Less
C. Equal
D. Either A. or B.; depends on the viscosity of the fluid - The valve used for very remote and accurate control of fluid is a _____________ valve?
A. Needle
B. Globe
C. Gate
D. Butterfly - In which type of fluid flow, the velocity of flow of fluid changes from point to point in the fluid at any instant ?
A. Rotational
B. Unsteady
C. Turbulent
D. Non-uniform - The inherent characteristic of an equal percentage valve relating flow rate ‘q’ with valve stem movement ‘x’ are described by the equation_________________?
A. dq/dx = K
B. dq/dx = K.q
C. dq/dx = K/q
D. dq/dx = Kq2 - The most suitable flow measuring device for the fluid flow measurement in a very large diameter pipeline is a____________________?
A. Weir
B. Pitot tube
C. Kennison nozzle
D. V-notch - In case of unsteady fluid flow, conditions & flow pattern change with the passage of time at a position in a flow situation. Which of the following is an example of unsteady flow ?
A. Discharge of water by a centrifugal pump being run at a constant rpm
B. Water flow in the suction and discharge pipe of a reciprocating pump
C. Water discharge from a vertical vessel in which constant level is maintained
D. Low velocity flow of a highly viscous liquid through a hydraulically smooth pipe - The pressure drop per unit length of pipe incurred by a fluid ‘X’ flowing through pipe is Δp. If another fluid ‘Y’ having both the specific gravity & density just double of that of fluid ‘X’, flows through the same pipe at the same flow rate/average velocity, then the pressure drop in this case will be__________________?
A. Δp
B. 2Δp
C. Δp2
D. Δp/2
