A. 2v2/gc
B. v2/2gc
C. ρv2/gc
D. ρ.v2/2gc
Related Mcqs:
- Bernoulli’s equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli’s equation? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible ?
A. A, C, D
B. B, D, E
C. A, B, E
D. A, D, E - The pressure drop per unit length of pipe incurred by a fluid ‘X’ flowing through pipe is Δp. If another fluid ‘Y’ having both the specific gravity & density just double of that of fluid ‘X’, flows through the same pipe at the same flow rate/average velocity, then the pressure drop in this case will be__________________?
A. Δp
B. 2Δp
C. Δp2
D. Δp/2 - What is the ratio of total kinetic energy of fluid passing per second to the value obtained on the basis of average velocity (for laminar flow through a circular pipe) ?
A. 0.5
B. 1
C. 1.5
D. 2 - A pipe has a porous section of length L as shown in the figure. Velocity at the start of this section of V0. If fluid leaks into the pipe through the porous section at a volumetric rate per unit area q(x/L)2, what will be axial velocity in the pipe at any „x‟? Assume incompressible one dimensional flow i.e., no gradients in the radial direction ?
A. VX = V0 + q (x3/L2D)
B. VX = V0 + ⅓q (x3/L2)
C. VX = V0 + 2q (x2/LD)
D. VX = V0 + (4/3) q (x3/L2D) - The net positive suction head (NPSH) of a centrifugal pump is defined as the sum of the velocity head and the pressure head at the_________________?
A. Discharge
B. Suction
C. Suction minus vapor pressure of the liquid at suction temperature
D. Discharge minus vapor pressure of the liquid at the discharge temperature - In case of turbulent flow of a Newtonian fluid in a straight pipe, the maximum velocity is equal to (where, Vavg = average fluid velocity)?
A. Vavg
B. 1.2 Vavg
C. 1.5 Vavg
D. 1.8 Vavg - The ratio of average fluid velocity to the maximum velocity in case of laminar flow of a Newtonian fluid in a circular pipe is_____________________?
A. 0.5
B. 1
C. 2
D. 0.66 - In which type of fluid flow, the velocity of flow of fluid changes from point to point in the fluid at any instant ?
A. Rotational
B. Unsteady
C. Turbulent
D. Non-uniform - For laminar flow of Newtonian fluids through a circular pipe, for a given pressure drop and length & diameter of pipe, the velocity of fluid is proportional to (where, μ = fluid viscosity ) ?
A. μ
B. 1/μ
C. √μ
D. 1/√μ - The kinetic energy correction factor for velocity distribution of laminar flow is_________________?
A. 0.5
B. 1.66
C. 1
D. 2
