An ideal plastic substance indicates no deformation, when stressed upto yield stress, but behaves like a Newtonian fluid beyond yield stress. Which of the following is an ideal plastic ?

Related Mcqs:

1. Bernoulli’s equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli’s equation? A. Fluid flow is frictionless & irrotational. B. Fluid flow is steady. C. Fluid flow is uniform & turbulent. D. Fluid is compressible. E. Fluid is incompressible ?

   A. A, C, D
   B. B, D, E
   C. A, B, E
   D. A, D, E

2. Deformation drag, which is caused by widespread deformation of fluid around the immersed body____________________?

   A. Occurs when NRe is very small
   B. Is primarily a friction drag
   C. Is independent of body length
   D. Depends mainly on cross-sectional shape

3. As per Newton’s law of viscosity, the shear stress for a given rate of angular deformation of fluid is proportional to (where, μ = fluid viscosity) ?

   A. 1/μ
   B. μ
   C. μ2
   D. 1/μ2

4. A fluid which has a linear relationship between the magnitude of applied shear-stress and the resulting rate of deformation is called a/an _____________ fluid?

   A. Newtonian
   B. Non-Newtonian
   C. Ideal
   D. Incompressible

5. A Bingham fluid of viscosity μ = 10 Pa.s and yield stress, η0 = 10 KPa, is shared between flat parallel plates separated by a distance of 10-3 m. The top plate is moving with a velocity of 1 m/s. The shear stress on the plate is________________?

   A. 10 KPa
   B. 20 KPa
   C. 30 KPa
   D. 40 KPa

6. For turbulent flow of Newtonian fluid in a circular cross-section pipe, the ratio of maximum to average fluid velocity is ________________?

   A. 0.5
   B. 1
   C. 0.66
   D. < 0.5

7. In case of turbulent flow of a Newtonian fluid in a straight pipe, the maximum velocity is equal to (where, Vavg = average fluid velocity)?

   A. Vavg
   B. 1.2 Vavg
   C. 1.5 Vavg
   D. 1.8 Vavg

8. For laminar flow of Newtonian fluids through a circular pipe, for a given pressure drop and length & diameter of pipe, the velocity of fluid is proportional to (where, μ = fluid viscosity ) ?

   A. μ
   B. 1/μ
   C. √μ
   D. 1/√μ

9. The ratio of average fluid velocity to the maximum velocity in case of laminar flow of a Newtonian fluid in a circular pipe is_____________________?

   A. 0.5
   B. 1
   C. 2
   D. 0.66

10. Which of the following is a Newtonian fluid ?

    A. Rubber latex
    B. Sewage sludge
    C. Quicksand
    D. Non-colloidal solution