1. maximum bending moment
2. shear force
3. punching shear
The correct answer is?
A. only (1)
B. (1) and (2)
C. (1) and (3)
D. (1), (2) and (3)
Civil Engineering Mcqs
Civil Engineering Mcqs for Preparation of Job Test and interview, freshers, Students, competitive exams etc. Multiple choice questions here are on topics such as Building Construction, Materials for Construction, Basic Surveying, Highway Engineering, Dams, Airport Engineering, Structural Analysis etc.
1. bottom face near counterfort
2. top face near counterfort
3. bottom face near centre of span
4. top face near centre of span The correct answer is
A. only (1)
B. only (2)
C. both (1) and (4)
D. both (2)and (3)
1. bottom face in front counterfort
2. inclined face in front counterfort
3. bottom face in back counterfort
4. inclined face in back counterEort
The correct answer is
A. (1) and (ii),
B. (2) and (3)
C. (1) and (4)
D. (3) and (4)
1. top face parallel to the wall
2. top face perpendicular to the wall
3. bottom face paralleUo the wall
4. bottom face perpendicular to the wall
The correct answer is ?
A. only (2) is correct
B. (1) and (2)are correct
C. (3) and (4) are correct
D. only (4) is correct
1. the vertical slab is designed as a continuous slab
2. the heel slab is designed as a continuous slab
3. the vertical slab is designed as a cantilever
4. the heel slab is designed as a cantilever
The correct answer is?
A. (1) and (ii)
B. (1) and(4)
C. (2) and (3)
D. (3) and (4)
1. Factor of safety for steel should be based on its yield stress,
2. Factor of safety for steel should be based on its ultimate stress,
3. Factor of safety for concrete should be based on its yield stress,
4. Factor of safety for concrete should be based on its ultimate stress.
The correct statements are
A. (1) and (3)
B. (1) and(4)
C. (2) and (3)
D. (2) and (4)
1. to increase shrinkage
2. to decrease shrinkage
3. to increase setting time
4. to decrease setting time
The correct answer is?
A. (1) and (3)
B. (1)and(4)
C. (2)and (3)
D. (2)and (4)
A. Lean mixes bleed more as compared to rich ones
B. Bleeding can be minimized by adding pozzuolana finer aggregate
C. Bleeding can be increased by addition ‘of calcium chloride
D. none of the above
A. Elastic modulus of high tensile steel is nearly the same as that of mild steel
B. Elastic modulus of high tensile steel is more than that of mild steel
C. Carbon percentage in high carbon steel is less than that in mild steel
D. High tensile steel is cheaper than mild steel
A. the front face in one direction
B. the front face in both directions
C. the inner face in one direction
D. the inner face in both directions
