A. Mass curve
B. Volume curve
C. Capacity curve
D. All are correct
Related Mcqs:
- generally useful life of a reservoir is considered terminated when its -gross storage is reduced by _______________ of the design capacity of the reservoir?
A. 100%
B. 80%
C. 50% l
D. 20% - Volume of water that unit volume of aquifer will give up by gravity pull is called ____________________?
A. Specific volume
B. Specific yield
C. Specific retention
D. All are correct - The height from the top of the embankment to the normal water level in canal .Dam – Reservoir etc, which allows for small waves to splash without over flow is called___________________?
A. Free board
B. Free space
C. Free faced
D. Free end – - An escape constructed with masonry or pitched with stones to dispose off surplus of tank or reservoir is called________________?
A. Bye-wash
B. paved-escape
C. Water escape
D. Disposal channel - The level above the or below the sea level which is also called zero level or datum is called ___________________?
A. Reduce level
B. Positive level
C. Soil level
D. Negative level - During the peak stage of river, there exist an out flow from river into the ground water reservoir, in such case river will be called _________________?
A. Influent stream
B. Effluent stream
C. Storm water stream
D. Seepage stream - The losses of irrigation water due to the seepage but That. does not join the under ground reservoir is called __________________?
A. Seepage losses
B. Absorption losses
C. Evaporation losses
D. Percolation losses - In high floods, to avoid spilling of flood water over the gates, a wall is provided from pond level to high Flood level. This wall spans for the entire length of regulator, rest on piers, sustain water pressure by its weight called_____________________?
A. Retaining wall
B. Divide wall
C. Breast wall
D. Cantilever wall - The ratio of change of discharge of an outlet to the rate of change in level of water surface in distributary at its normal depth is called ____________________?
A. Sensitivity
B. Flexibility
C. Durability
D. Flow ability - The percentage of the volume of water filled in voids to the total volume of solids of soil grains is called__________________?
A. Void ratio
B. Degree of compaction
C. Degree of saturation
D. Volume of saturation