A. better burning
B. more calorific value
C. less radiation loss
D. medium sized units
E. stoker fired boilers
Related Mcqs:
- The specific fuel consumption for a petrol engine first decreases with increase in fuel air ratio and then increases with further increase in fuel air ratio. The minimum value occurs in the range of__________________?
A. lean mixture
B. chemically correct mixture
C. rich mixture
D. unpredictable
E. none of the above - Heating value of fuel used is as on fired basis. If it is reported for dry or moisture free fuel, then latter should be multiplied by the following factor to correct for as fired value ___________________?
A. (1- moisture content)
B. (1 + moisture content)
C. 1 + moisture content
D. 1 – moisture content - Which is correct statement about reaction time for autoignition of fuel and the fuel air ratio__________________?
A. lean mixture has high reaction time
B. rich mixture has high reaction time
C. chemically correct mixture has mini-mum reaction time
D. all of the above
E. non of the above - Auto-ignition reaction time for petrol engine first decreases with increase in fuel air ratio, reaches a minimum value and then increases with subsequent increase in fuel air ratio. The minimum value occurs in the region of________________?
A. Lean mixture
B. Chemically correct fuel air ratio
C. Rich mixture
D. Unpredictable - The m.e.p. of a petrol engine first increases as the fuel air ratio is increased and then decreases on further increase in fuel air ratio. The M.E.P is maximum in the zone of________________?
A. lean mixture
B. chemically correct mixture
C. rich mixture
D. unpredictable
E. none of the above - For combustion of a fuel, following is essential_____________________?
A. correct fuel air ratio
B. proper ignition temperature
C. 02 to support combustion
D. all the three above
E. none of the above - Presence of moisture in fuel oil would____________________?
A. keep the burner tips cool
B. aid in proper combustion
C. cause sputtering, possibly extinguish¬ing flame
D. clean the nozzles
E. reduce flame length - The size of a boiler drum in pulverised fuel fired boiler,as its size and capacity, (steam pressure and flow ratings) increase __________________?
A. increases
B. decreases
C. remains unchanged
D. increases/decreases depending on steam temperature requirements
E. unpredictable - Which is not correct statement about effect of sulphur in fuel ___________________?
A. it has heating value
B. it helps in electrostatic precipitation of ash in flue-gases
C. it leads to corrosion of air heaters, ducting, etc. if flue gas exit temperature is low
D. it erodes furnace walls
E. none of the above - Pour point of fuel oil is the____________________?
A. lowest temperature at which oil will flow under set condition
B. storage temperature
C. temperature at which fuel is pumped through burners
D. temperature at which oil is transported
E. none of the above
