A. increases
B. decreases
C. remains unchanged
D. increases/decreases depending on steam temperature requirements
E. unpredictable
Related Mcqs:
- Heating value of fuel used is as on fired basis. If it is reported for dry or moisture free fuel, then latter should be multiplied by the following factor to correct for as fired value ___________________?
A. (1- moisture content)
B. (1 + moisture content)
C. 1 + moisture content
D. 1 – moisture content - The specific fuel consumption for a petrol engine first decreases with increase in fuel air ratio and then increases with further increase in fuel air ratio. The minimum value occurs in the range of__________________?
A. lean mixture
B. chemically correct mixture
C. rich mixture
D. unpredictable
E. none of the above - The condition of steam in boiler drum is always ___________________?
A. dry
B. wet
C. saturated
D. supersaturated
E. superheated - The high pressure boiler is oiie producing steam at a pressure more than_________________?
A. atmospheric pressure
B. 5 kg/cm2
C. 10 kg/cm2
D. 40 kg/cm2
E. 75-80 kg/cm2 - Auto-ignition reaction time for petrol engine first decreases with increase in fuel air ratio, reaches a minimum value and then increases with subsequent increase in fuel air ratio. The minimum value occurs in the region of________________?
A. Lean mixture
B. Chemically correct fuel air ratio
C. Rich mixture
D. Unpredictable - The basic purpose of drum in boiler is to_____________________?
A. serve as storage of steam
B. serve as storage of feed water for water wall
C. remove salts from water
D. separate steam from water
E. control level - The safety valve on boiler drum compared to safety valve on super heater is set at ________________?
A. same value
B. higher value
C. lower value
D. lower/higher depending on steam flow
E. unpredicatble - The steam temperature with increase in load in case of a boiler fitted with radiation super heater________________?
A. increases
B. decreases
C. remains unaffected
D. first increases and then decreases
E. unpredictable - Increase in pressure at the outer edge of a drum of radius R due to rotation at corad/sec, full of liquid of density p will be___________________?
A. pco2/?2
B. pco2/?2/2
C. 2pa2R2
D. pa2R/2
E. none of the above - In locomotive boiler, maximum steam pressure is limited to_______________?
A. 1 kg/cm2
B. 5 kg/cm2
C. 10 kg/cm2
D. 18 kg/cm2
E. 31 kg/cm2