Heat of neutralisation of a strong acid and strong base is always a constant value, i.e., 57 KJ/Kg mole. This is because_________________?

Related Mcqs:

1. Heat of neutralisation of HCl and NaOH is – 57.46 kJ/Kg mole. The heat of ionisation of water will be _____________ kJ/Kg mole?

   A. 57.46
   B. -57.46
   C. 114.92
   D. -28.73

2. The accumulation in a steady state combustion process, burning 1 kg mole of carbon with 1 kg mole of oxygen thereby producing 1 kg mole of carbon dioxide, is _____________ kg mole?

   A. 1
   B. 0
   C. 16
   D. 44

3. In which of the following case of mixing of a strong acid with strong base (each of 1N concentration), temperature increase will be the highest ?

   A. 30 c.c acid and 30 c.c base
   B. 20 c.c acid and 25 c.c base
   C. 15 c.c acid and 35 c.c base
   D. 35 c.c acid and 15 c.c base

4. The combustion equations of carbon and carbon monoxide are as follows: C + O2 = CO2, ΔH = – 394 kJ/kg .mole CO + ½ O2 = CO2, ΔH = – 284.5 kJ/kg. mole. The heat of formation of CO is _____________ kJ/kg. mole?

   A. -109.5
   B. +109.5
   C. +180
   D. +100

5. A rigid vessel containing three moles of nitrogen gas at 30°C is heated to 250°C. Assume the average capacities of nitrogen to be Cp = 29.1 J/mole.°C and, Cv = 20.8 J/mole.°C. The heat required, neglecting the heat capacity of the vessel, is__________________?

   A. 13728 J
   B. 19206 J
   C. 4576 J
   D. 12712 J

6. Heat capacity of air can be approximately expressed as, Cp = 26.693 + 7.365 x10-3 T, where, Cp is in J/mole.K and T is in K. The heat given off by 1 mole of air when cooled at atmospheric pressure from 500°C to – 100°C is ____________________?

   A. 10.73 kJ
   B. 16.15 kJ
   C. 18.11 kJ
   D. 18.33 kJ

7. A very dilute solution is prepared by dissolving ‘x1’ mole of solute in ‘x2’ mole of a solvent. The mole fraction of solute is approximately equal to_________________?

   A. x1/x2
   B. x2/x1
   C. 1 – (x1/x2)
   D. 1/x2

8. A fluid gas produced on burning furnace oil contains 0.15 gm mole of CO2, 0.05 gm mole of oxygen and 0.80 gm mole of N2. What is its molecular weight ?

   A. 28.6
   B. 30.0
   C. 30.6
   D. 32.6

9. A butane isomerisation process produces 70 k.mole/hr of pure iso-butane. A purge stream removed continuously, contains 85% n-butane and 15% impurity (mole%). The feed stream is n-butane containing 1% impurity (mole%). The flow rate of the purge stream will be_________________?

   A. 3 kmole/hr
   B. 4 kmole/hr
   C. 5 kmole/hr
   D. 6 kmole/hr

10. One mole of methane undergoes complete combustion in a stoichiometric amount of air. The reaction proceeds as CH4 + 2O2 → CO2 + 2H2O. Both the reactants and products are in gas phase. ΔH°298 = – 730 kJ/mole of methane. Mole fraction of water vapour in the product gases is about_____________________?

    A. 0.19
    B. 0.33
    C. 0.40
    D. 0.67