A. λ
B. λ/2
C. λ/4
D. λ/8
Submitted by: Rizwan Ayub Saadi
Related Mcqs:
- The distance between any two consecutive crests or troughs is called____________________?
A. frequency
B. period
C. Wave length
D. phase difference - When two bodies move toward each other with constant speeds the distance between them decreases at the rate of 6m / sec. If they move in the same direction the distance between them increases at the rate of 4m/sec. Then their speeds are________________?
A. 5m/s, 1m/s
B. 3m/s, 3m/s
C. 6m/s, 1m/s
D. 4m/s, 2m/s - When one mirror of a Michelson Interferometer is moved a distance of 0.5 mm we observe 2000 fringes. What will be wavelength of light used ?
A. 5000 nm
B. 5000A
C. 500m
D. 2000um - A stationary wave is set up in the air column of a closed pipe. At the closes end of the pipe _____________________?
A. always an node in formed
B. always an antinode is formed
C. neither node nor antinode is formed
D. sometimes a node and sometimes an antinode is formed - When the source of sound moves away form a stationary listener then ______________ occurs?
A. an apparent increase in frequency
B. an apparent decrease in frequency
C. an apparent decrease in wavelength
D. no apparent change in frequency - The speed of stationary waves in a stretched string are independent of___________________?
A. Number of loops
B. Tension in the string
C. Point where string is plucked
D. both A and C - Fundamental frequency of stationary waves in open pipe is ______________ times the frequency in closed pipe?
A. One
B. Two
C. Four time
D. None of these - Wavelength of X-rays falling at glancing angle of 30? on a crystal with atmic spacing 2 x 10-10 for the fist order diffraction is________________?
A. 4 x 10-10 m
B. 2 x 10-10 m
C. 0.02×10-10m
D. 20×10-10m - Radiation with wavelength longer than red lights______________?
A. ultraviolet rays
B. X-rays
C. infra red radiation
D. visible radiation - The minimum wavelength of X-rays can further be reduced by _______________?
A. Reducing the pressure or cooling the target
B. Increasing the temperature of the filament.
C. Using a target element of higher atomic number
D. Increasing the potential difference between the cathode and the target