A. Zinc oxide-eugenol
B. Reversible hydrocolloid
C. Alginate
D. Polysulphide rubber
Related Mcqs:
- Alginate impression material is similar to Agar-agar impression material in the following respect________________?
A. Gelation increase in both on increase in temperature
B. Mixing time is increased to reduce the setting time
C. Deformation during removal of impression occurs due to distortion of gel fibers
D. Both can be re-used for fresh impressions - Best impression material to be used for securing impression after crown preparation_______________?
A. Alginate
B. Agar
C. Elastome
D. Zno paste - Which of the following impression materials is easy to pour and difficult to remove the stone cast from the impression ?
A. Addition polysilicone
B. Condensation polysilicone
C. Polyether
D. Polysulfide - Agar impression materials differ from alginate impression materials in that the former sets by_______________?
A. Mechanical action of saliva
B. Physical change
C. Evolution
D. Chemical change - All of the following statements about Type II silicon impression material are true EXCEPT_______________?
A. They evolve hydrogen when cast if they are not fully cured
B. They exhibit a very low setting shrinkage
C. They have a lower tear resistance than polysulphide rubbers
D. They set by condensation polymerisation - Which of the following impression material is elastic________________?
A. Impression compound
B. Zinc Oxide eugenol (ZOE) paste
C. Wax
D. Polyvinyl siloxane - Which of the following is used as surface hardener in Impression material ?
A. 2% Potassium sulfate
B. 0.2% Potassium sulfate
C. 2% sodium sulfate
D. 4% Potassium sulfate - Which of the following best describes the working time of impression material ?
A. After the start of appearing elastic properties of impression material
B. Just after the start of appearing elastic properties of impression material
C. The time for start of mixing till just before the start of appearing elastic properties of impression material
D. Loss of lusture of impression material - Which of the following best describes the working time of elastomeric impression material ?
A. After the start of appearing elastic properties of impression material
B. Just after the start of appearing elastic properties of impression material
C. Just before the start of appearing elastic properties of impression material
D. Loss of luster of impression material - Which of the following is true about Agar hydrocolloid impression material ?
A. Liquefies between 71 – 100°C
B. Solidfies between 50 – 70°C
C. Facilitates fabrication of metal dyes
D. Cannot register fine surface details
