A. Mineral oil
B. Surfactant
C. Water
D. Plasticizer
Related Mcqs:
- All of the following can be used to slow down the setting of Zinc oxide eugenol impression paste EXCEPT_________________?
A. Adding a small amount of glycerine
B. Adding a small amount of water
C. Altering the amounts of the two pastes used
D. Cooling mixing slab - Impression compound has which of the following characteristic property ?
A. Low thermal conductivity
B. High flow property
C. Degradation is presence of moisture
D. Remain distortion free up to 72 hrs. pouring can be safely delayed - Which of the following impression material is elastic________________?
A. Impression compound
B. Zinc Oxide eugenol (ZOE) paste
C. Wax
D. Polyvinyl siloxane - Which of the following impression material is rigid ?
A. Zinc oxide-eugenol
B. Reversible hydrocolloid
C. Alginate
D. Polysulphide rubber - Impression compound is characterized by all of the following except_______________?
A. Warps at room temperature
B. Is a thermoset material
C. Shows increased flow when kneaded with water
D. Low coefficient of thermal conductivity - Which of the following is correct regarding chemical setting of condensation silicone_______________?
A. Polymerization occurs with repeated elimination of small molecules
B. Polymerization occurs with elimination of single byproduct
C. By condensation of repeated molecules of monomers
D. Condensation does not occur at all - Which of the following component acts as an accelerator in ZOE impression paste ?
A. Zinc Sulphate & Zinc chloride
B. Zinc chloride & Eugenol
C. Zinc Sulphate & Eugenol
D. Glycerin - Which of the following best describes the working time of elastomeric impression material ?
A. After the start of appearing elastic properties of impression material
B. Just after the start of appearing elastic properties of impression material
C. Just before the start of appearing elastic properties of impression material
D. Loss of luster of impression material - Which of the following is correct glass transition temperature of Impression compound ?
A. 43.5°C
B. 39°C
C. 65°C
D. 100°C - When making a polysulphide impression for a caste crown, custom trays are usually preferred over stock trays for all of the following reasons except_______________?
A. Custom trays facilitate uniform contraction of impression material
B. Custom trays require less impression material
C. Stock trays may be short in the flange area
D. Impressions made n the custom trays are easier to remove from the mouth
