A. Composites
B. Unfilled resins
C. Amalgam
D. Polycarboxylate
Related Mcqs:
- About polymerization shrinkage of composite all are true, except______________?
A. Polymerization shrinkage is greater if bonded surface area is lesser than unbounded surface area
B. Polymerization shrinkage is high if within the enamel margins
C. Acid etching and priming will decrease polymerization shrinkage
D. Microleakage can occur because of polymerization shrinkage - Along with polymerisation shrinkage, one of the major disadvantages of polymethyl methacrylate as denture base resin are its poor_____________?
A. Biological properties
B. Thermal properties
C. Mechanical properties
D. Esthetic properties - What is the polymerization shrinkage if 3:1 powder: liquid ratio is used____________?
A. 6%
B. 8%
C. 10%
D. 21% - Glossy smooth margins of a casting are due to_____________?
A. Shrinkage of alloy on cooling
B. Investment breakdown
C. Incomplete wax elimination
D. Incomplete gas elimination - The maximum shrinkage during firing proces in ceramic occurs in__________________?
A. High Bisque stage
B. Low Bisque stage
C. Medium Bisque stage
D. Fusion stage - Condensation shrinkage of porcelain during firing depends on__________________?
A. Rate of arriving at firing temperature
B. Uniformity of particle size
C. Shape and size of particle
D. Type of investment used - The linear solidification shrinkage of Type IV Ni-Cr based alloys is_______________?
A. 2.3%
B. 1.56%
C. 1.37%
D. 3% - Casting shrinkage is compensated by_______________?
A. Thermal expansion
B. Hygroscopic expansion
C. Wax expansion
D. All of the above - Localised shrinkage porosity is seen when there________________?
A. Thin sprue
B. No reservoir
C. Investment heated strongly
D. Inadequate air discharge - The yeast which shows thick gelatinous capsule and positive for mucicarmine is_____________?
A. Cryptococcus
B. Histoplasmosis
C. Blastomycosis
D. Paracoccidiomycosis