A. Higher solubility in saliva
B. Lower modulus of elasticity
C. Esthetic excellence
D. Lower thermal co-efficient of expansion
Advertisement
Related Mcqs:
- The advantage of unfilled methyl methacrylate is that______________?
- A. It can be finished smoothly B. It has a low degree of flow C. It’s non-irritation to pulp D. It’s wear resistant is high...
- A patient who has had a recent amalgam filling in the upper teeth has a gold filling in the lower teeth, the patient complains of pain. The reason for this can be mainly_____________?
- A. Improper amalgam filling B. Pulp exposure C. Galvanism D. None of the above...
- One of the claims for the superiority composite resin restoration over silicate cement restorations is that the resin restorations_____________?
- A. Prevent galvanic action B. Are practically insoluble in oral fluids C. Adapt to the walls of the cavity better D. Have a higher coefficient of thermal expansion...
- Denture acrylics contain cross-linking agents mainly to improve their_____________?
- A. Internal color B. Tissue compability C. Surface hardness D. Craze resistance...
- Pitting of direct filling old restoration usually results from_________________?
- A. Using contaminated gold foil B. Poor finished preparation C. Improper stepping of condenser point D. Using small condenser point...
- Which of the following is true about direct filling gold______________?
- A. Properly condensed mat gold has no voids B. Whatever may be the type voids are inherent C. Voids can be avoided with manual condensation D. None of the above...
- Direct filling gold formed by electrolytic precipitation is called by all the terms EXCEPT______________?
- A. Crystalline B. Granular gold C. Mat gold D. Sponge gold...
- Inorganic phase of the composites aid in_______________?
- A. Increasing the mechanical strength B. Decreasing the coefficient of thermal expansion C. Reducing the polymerization shrinkage D. All of the above...
- What is the disadvantage of using composites as restorative material ?
- A. Increased thermal conductivity B. Decreased wear resistance C. Decreased thermal conductivity D. None of the above...
- The particle size in microfilled composites is_____________?
- A. 0.05 to 0.04mm B. 0.5 to 1.0 microns C. 0.01 to 0.1 microns D. 0.3 to 0.4mm...
Advertisement