A. Close adaptation to soft tissues
B. With drawl without permanent distortion
C. Reproduction of surface details
D. Compatibility with gypsum products
Related Mcqs:
- Alginate impression material is similar to Agar-agar impression material in the following respect________________?
A. Gelation increase in both on increase in temperature
B. Mixing time is increased to reduce the setting time
C. Deformation during removal of impression occurs due to distortion of gel fibers
D. Both can be re-used for fresh impressions - Best impression material to be used for securing impression after crown preparation_______________?
A. Alginate
B. Agar
C. Elastome
D. Zno paste - Before pouring an elastic impression it is washed with slurry of water and stone to______________?
A. Increase gel strength
B. Prevent syneresis
C. Prevent distortion
D. Wash off saliva on impression - Which one of the following impression materials is elastic, sets by a chemical reaction and is catalyzed by chloroplatinic acid_______________?
A. Condensation silicone
B. Polyether
C. Polysulfide
D. Poly vinyl siloxane - Which of the following impression materials is easy to pour and difficult to remove the stone cast from the impression ?
A. Addition polysilicone
B. Condensation polysilicone
C. Polyether
D. Polysulfide - Agar impression materials differ from alginate impression materials in that the former sets by_______________?
A. Mechanical action of saliva
B. Physical change
C. Evolution
D. Chemical change - Rinsing of the impression is important to________________?
A. Remove excess impression material
B. Remove saliva
C. Hydrate the impression
D. Accelerate the setting - Which of the following impression material is elastic________________?
A. Impression compound
B. Zinc Oxide eugenol (ZOE) paste
C. Wax
D. Polyvinyl siloxane - Dimensional stability of elastomeric impression material can be given in descending order as_____________?
A. Polysulphide > polyether > Condensation silicone > Addition silicone
B. polyether > Condensation silicone > Polysulphide > Addition silicone
C. Addition silicone > polyether > Polysulphide > Condensation silicone
D. Addition silicone> Condensation silicone > Polysulphide > polyether - What is the minimum thickness of the elastomeric impression material for an accurate impression_______________?
A. 2 mm
B. 2-4 mm
C. Greater than 3 mm
D. Maximum in the area of operation
