One bottle system of adhesive resins_____________?

Related Mcqs:

1. Which is the cement with adhesive properties ?

   A. Zinc oxide eugenol
   B. Zinc polycarboxylate
   C. SIlicate
   D. Glass ionomer
   E. Both B & D

2. The most commonly used, most biocompatible and adhesive cement is______________?

   A. Zinc phosphate
   B. Zinc oxide eugenol
   C. Calcium hydroxide
   D. Glass ionomer

3. A good adhesive should possess all of the following EXCEPT________________?

   A. High adherend wetting
   B. High contact angle
   C. Low contact angle
   D. High flow

4. The wetting of an adherent surface by an adhesive is related to________________?

   A. Surface energy of the adherent
   B. Surface texture of the adherent
   C. Surface tension of the adherent
   D. Nature of the adherent that is crystalline or amorphous

5. Angles between Adhesive and Adherent is Zero degree, it indicates_______________?

   A. Complete wetting of surfaces
   B. Rough surfaces between Adhesive & Adherent
   C. Adherent and Adhesive molecules are tangent to each other
   D. Irregularities present between Adherent surfaces

6. The transmembrane adhesive molecules present in hemi desmosomes which specifically binds to basal lamina glycoprotein laminin are______________?

   A. Integrin a6-B4
   B. The catenins desmoplakin
   C. cadherins desmoglein
   D. a and B catenin

7. Streptococcus mutans produces an adhesive polymer from sucrose, known as:__________?

   A. Levans
   B. Lectins
   C. Glucans
   D. Polyfructans

8. All of the following statements about the differences between self-polymerizing acrylic resins and heat-cured resins are true EXCEPT______________?

   A. The former have a lower molecular weight
   B. The former have higher residual monomer content
   C. The former are more porous
   D. The former have greater transverse strength

9. Quartz tungsten light cure device minimum output of energy should not be less than_____________?

   A. 300 mw/sm2
   B. 350 mw/cm2
   C. 400 mw/cm2
   D. 450 mw/cm2

10. The imperfection seen on the lingual flange of a lower denture caused by rapid heating during a curing cycle is called_____________?

    A. Localised Shrinkage porosity
    B. Gas inclusion porosity
    C. Micro porosity
    D. Surface porosity