A. Above the proportional limit a material function in a plastic manner, while below the proportional limit it behaves as an elastic
B. Above the proportional limit a material functions in an elastic manner, while below the proportional limit it behaves as an plastic
C. Either A or B
D. Neither A or B
Related Mcqs:
- A restorative material which has a high proportional limit, compared with one with a lower proportional limit would have________________?
A. Greater ductility
B. Greater toughness
C. A higher modulus of elasticity
D. A higher modulus of elasticity
E. More resistance to permanent deformation - The greatest stress which may be produced in a material such that stress is directly proportional to the strain is know as_____________?
A. The elastic limit
B. The proportional limit
C. The yield strength
D. Modulus of elasticity - Adrenal gland has two parts; cortex and medulla. Which of the following is correct______________?
A. Cortex is under the control of ACTH
B. Both cortex and medulla are under the control of autonomic nervous system
C. Cortex is exocrine and medulla is endocrine
D. All of the above - The strain that occurs when a material is stressed to its proportional limit is______________?
A. Resilience
B. Maximum flexibility
C. Toughness
D. Elastic limit - Which of the following physical property can be used to estimate indirectly the proportional limit of gold alloys ?
A. Vickers’s hardness number
B. Knoop hardness number
C. Brinell hardness number
D. Rockwell hardness number - The proportional limit is defined as______________?
A. The maximum stress in a structure
B. The minimum force required to cause a structure to break
C. The maximum stress that can be induced without permanent deformation
D. The maximum elongation under tension that can be measured before failure - The point at which a stress of a material exhibits a specific limited deviation P is called_______________?
A. Proportional limit
B. Tensile strength
C. Ultimate strength
D. Yield strength - Alginate impression material is similar to Agar-agar impression material in the following respect________________?
A. Gelation increase in both on increase in temperature
B. Mixing time is increased to reduce the setting time
C. Deformation during removal of impression occurs due to distortion of gel fibers
D. Both can be re-used for fresh impressions - Which one of the following is the result of applying a load to a wire below its modulus of elasticity on a load deflection diagram ?
A. Fracture of the wire
B. permanent deformation
C. Spring back
D. Increase in stiffness - Brinnel hardness number of a dental gold alloy is directly proportional to its______________?
A. Tensile strength
B. Elongation
C. Modulus of elasticity
D. Modulus of resilience
