To transmit power from one rotating shaft to another whose axes are neither parallel nor intersecting, use__________________?

Related Mcqs:

1. The type of coupling used to join two shafts whose axes are neither in same straight line nor parallel, but intersect is______________________?

   A. flexible coupling
   B. universal coupling
   C. chain coupling
   D. Oldham’s coupling
   E. American coupling

2. It is required to connect two parallel shafts, the distance between whose axes is small and variable. The shafts are coupled by_______________?

   A. universal joint
   B. knuckle joint
   C. Oldham’s coupling
   D. flexible coupling
   E. electromagnetic coupling

3. With single Hooke’s joint it is possible to connect two shafts, the axes of which have an angular misalignment up to ________________?

   A. 10°
   B. 20°
   C. 30°
   D. 40°
   E. 60°.

4. Shaft revolving in a bearing is the following type of pair________________?

   A. lower pair
   B. higher pair
   C. spherical pair,
   D. cylindrical pair
   E. bearing pair

5. An eccentric sheave pivoted at one point rotates and transmits oscillatory motion to a link whose one end is pivoted and other end is connected to it. This mechanism has___________________?

   A. 2 links
   B. 3 links
   C. 4 links
   D. 5 links
   E. none of the above

6. In automobiles the power is transmitted from gear box to differential through _________________?

   A. bevel gear
   B. universal joint
   C. Hooke’s joint
   D. Knuckle joint
   E. Oldham’s coupling

7. Transmission of power from the engine to the rear axle of an automobile is by means of___________________?

   A. compound gears
   B. worm and wheel method
   C. Hooke’s joint
   D. crown gear
   E. bevel gears

8. T Jie horse power transmitted by a belt is dependent upon _________________?

   A. tension on tight side of belt
   B. tension on slack side of belt
   C. radius of pulley
   D. speed of pulley
   E. all of the above

9. A circular bar moving in a round hole is an example of_______________?

   A. incompletely constrained motion
   B. partially constrained motion
   C. completely constrained motion
   D. successfully constrained motion
   E. none of the above

10. A mechanism is an assemblage of ____________________?

    A. two links
    B. three links
    C. four links or more than four links
    D. all of the above
    E. none of the above