A. 100°C
B. above dew-point temperature of flue gases
C. below dew-point temperature of flue gases
D. less than wet bulb temperature of flue gases
E. above wet bulb temperature of flue gases
Related Mcqs:
- Gardually increasing temperature of flue gases at inlet to chimney for given steam outputs is an indication of__________________?
A. higher effectiveness of boiler
B. high calorific value coal being burnt
C. fouling of heat transfer surfaces
D. raising of steam temperature
E. leakage of air - With increase in load, radiant super heater has____________________?
A. drooping characteristic
B. lihear characterisstic
C. rising characteristic
D. flat characteristic
E. none of the above - The safety valve on boiler drum compared to safety valve on super heater is set at ________________?
A. same value
B. higher value
C. lower value
D. lower/higher depending on steam flow
E. unpredicatble - In order to prevent formation of carbon on the injector, the temperature of nozzle tip should be__________________?
A. less than 100°C
B. between 100-250°C
C. between 250 – 300°C
D. between 400 – 500°C
E. between 500 – 1000°C - The diameter of internal flue tubes in a Lancashire boiler compared to its shell is_________________?
A. one-half
B. one-third
C. one-fourth
D. one-fifth
E. two-fifth - The number of flue tubes in Lancashire boiler is_________________?
A. zero
B. one
C. two
D. four
E. many - The knocking in diesel engines for given fuel, will be__________________?
A. enhanced by increasing compression ratio
B. enhanced by decreasing compression ratio
C. unaflected by compression ratio
D. first enhanced by increasig compression ratio upto a limit beyond which it will be suppressed
E. dependent on other factors - Primary air is the air used to__________________?
A. provide air around burners for obtaining optimum combustion
B. transport and dry the coal
C. convert CO (formed in lower zone of furnace) into C02 at higher zone
D. air-delivered by forced draft fan
E. none ot the above - Tertiary air is the air used to____________________?
A. provide air around burners for obtaining optimum combustion
B. transport and dry the coal
C. cool the scanners
D. supply air for ignitors
E. convert CO (formed in lower zone of furnace) into C02 at higher zone - At very low temperature, the melting and boiling temperatures become equal. This temperature is____________________?
A. 373°K
B. 273.16°K
C. 303°K
D. 0°K.
E. 300°K