A. jointless section
B. homogeneous section
C. perfect section
D. manufactured section
E. seamless section
Related Mcqs:
- The distance between the centres of the rivets in adjacent rows of zig-zag riveted joint is known as ____________________?
A. pitch
B. back pitch
C. diagonal pitch
D. diametral pitch
E. lap - Diamond riveted joint can be adopted in the case of following type of joint _____________________?
A. butt joint
B. lap joint
C. double riveted lap joints
D. all types of joints
E. none of the above - A riveted joint in which every rivet of a row is opposite to other rivet of the outer row, is known as______________________?
A. chain riveted joint
B. diamond riveted joint
C. criss-cross riveted joint
D. zig-zag riveted joint
E. none of the above - The weakest section of a diamond riveting is the section which passes through ___________________?
A. the first row
B. the second row
C. the central row
D. one rivet hole of the end row
E. none of the above - The M.I. of hollow circular section about a central axis perpendicular to section as compared to its M.I. about horizontal axis is________________?
A. same
B. double
C. half
D. four times
E. one fourth - During a tensile test on a specimen of 1 cm cross-section, maximum load observed was 8 tonnes and area of cross-section at neck was 0.5 cm2. Ultimate tensile strength of specimen is___________________?
A. 4 tonnes/cm2
B. 8 tonnes/cm2
C. 16 tonnes/cm2
D. 22 tonnes/cm2
E. none of the above - A riveted joint in which the number otrivets decrease from innermost to outer most row is called__________________?
A. chain riveted joint
B. diamond riveted joint
C. criss-cross riveted joint
D. zig-zag riveted joint
E. none of the above - Efficiency of a riveted joint is the ratio of its strength (max. load it can resist without failure) to the strength of the unpunched plate in_________________?
A. tension
B. compression
C. bearing
D. any one of the above
E. none of the above - If a part is constrained to move and heated, it will develop ____________________?
A. principal stress
B. tensile stress
C. compressive stress
D. shear stress
E. no stress - If a material expands freely due to heating it will develop ____________________?
A. thermal stresses
B. tensile stress
C. bending
D. compressive stress
E. no stress
